Lantronix
ION x6010 User Guide
33493 Rev. F
Page 161 of 261
Error: parameter out of range, level1 port-id range is (1 .. 15)!
Error: parameter out of range, level2 port-id range is (1 .. 16)!
Error: parameter out of range, level3 port-id range is (1 .. 16)!
Error: parameter out of range, chassis-id range is (1 .. 16)!
Error: parameter out of range, level1 attachment port-id range is (1 .. 16)!
Error: parameter out of range, level2 attachment port-id range is (1 .. 16)!
You used the
go
command to move to a port, but the command was not accepted. For example:
C1 S7 L1D>
go l1p=0
Error: parameter out of range, level1 port-id range is (1 .. 15)!
C1 S7 L1D>
1.
Make sure this is the port that you want. See “
Managing Device and Port Hierarchy Using CLI Com-
mands
”
.
2.
Re-enter the
go
command.
3.
If the problem persists, contact Technical Support.
Cannot show cable length for fiber port!
You entered the command to display the length of the copper cable for a port that does not support it.
1.
Make sure the NID supports the
show cable length
command (only for x2110).
2.
Verify the command syntax. See the related
User Guide
manual.
3.
Type
show ether config
to show the Ethernet port’s configuration.
4.
If the problem persists, contact Technical Support.
Auto-negotiation is enabled, you can not set port duplex now!
You entered the command to assign a duplex mode, but the command is not functional if Auto-
negotiation is currently enabled.
1.
Either leave the Auto-negotiation setting and use the current duplex setting, or disable
AutoNegotiation and set the Duplex mode as required.
2.
Use the
show ether config
command to display the current Auto-negotiation and Duplex settings.
3.
If the problem persists, contact Technical Support.