![background image](http://html1.mh-extra.com/html/gima/35306/35306_manual_2228144035.webp)
35
ENGLISH
Battery life
: Provided that a battery is new and fully charged, the minimal working time of the monitor with accessories
connected is declared in the table below:
Name
Battery life
Patient Monitor
More than 120min
NOTE:
When the device is working, it take
s
at least 10 hours to charge battery from empty state to 90% charged.
The provided battery of the monitor must be recharged after transportation or storage. So if the monitor is
switched on without being connected to the AC power supply, it may not work properly due to insufficient battery
power.
: Working power supply indicator and the description is as shown below.
AC power
indicator
Working power
supply indicator
Description
Status
On
Off
The monitor is powered by the AC power supply and it is in off status
Off
On
The monitor is powered by the built-in battery power supply
On
On
The monitor is powered by the AC power supply and the battery is being
charged
3.2.2 Turning the Monitor On
The system performs self-test and enters initial display after the monitor is switched on, and the alarm rings to inform the
user that they can begin operating the monitor.
1. Check all the applicable functions to make sure that the monitor works normally.
2. If the built-in battery is applied, please recharge it after using the monitor to ensure sufficient power storage. It
will take at least 10 hours to charge battery from depletion to 90% charge.
3. Press the Power on/off key on the front panel of the monitor to start the monitor.
Do not use this device to monitor the patient if there are indications of damage or reminders of error. Please
contact the local dealer or our company.
The battery powered monitor continues to run without interruption when AC mains power is lost.
Start the monitor again 1 minute later after it is switched off. When the monitor is switched off allow one minute
before switching it back on so that the monitor powers off correctly.
3.2.3 Starting Monitoring
1. Decide which parameter measurements you want to make.
2. Connect the required modules, patient cables and sensors.
3. Check that the patient cables and sensors are correctly connected.
Summary of Contents for 35306
