Gima 35306, Manual, Page: 85 / 693

85
ENGLISH
Condition 1:
If the value difference between current SpO
2
value and the average value in the latest 1 minute is larger than the set
threshold, and it keeps true for at least 8 seconds, then a SE is generated.
Condition 2:
When the current SpO
2
value is between 90% and 100%, and the value difference between current SpO
2
value and the
average value in previous second is larger than the set threshold, then a SE is generated too.
10.7 Nellcor SpO
2
Module (Optional)

If your monitor is configured with Nellcor SpO
2
Module, then the SpO
2
related setting window is as shown in below
figure.

SE Threshold(%) : set the threshold of oxygen desaturation event (%), the value range is from 1 to 12, step is 1. The
default is 3(%).

SatSeconds : SatSeconds sensitivity setting, to set the max buffering time of activating SpO
2
alarm. Options are “0”,
“10”, “20”, “50” and “100”. If you set SatSeconds as “0”, it means to turn off the SatSeconds alarm management
function.
The over-limit points multiplied over-limit seconds makes SatSeconds.
SpO
2
panel for Nellcor SpO
2
module:
Notes:
1. When inserting finger into the probe cushion, then searching pulse icon “ ” appears on the upper side of the SpO
2
panel. However, once the SpO
2
/PR readings appear, or probe/ finger is off, then icon “ ” will disappear.
2. When interference (caused by e.g. shaking finger) appears, then icon “ ” appears on the upper middle side of the
SatSeconds icon and sensitivity setting “ Interference” icon