Gima 35306, Manual

Page: 38 / 693

38
ENGLISH
3.6 Setting the Screens
G enerally, in general view screen, there are 3 to 7 traces of waveforms in the waveform area, and 2 to 7 parameter
panels in the parameter area. Each waveform trace shows specific signal waveform (eg. ECG waveform, plethysmogram
and so on), you can also disable this trace. Each parameter panel shows one or one group of parameter value and the
corresponding status.
Waveform area locates at the left part of screen. The display order of waveforms in a view is configurable. The default
order from up to down is waveform 1, waveform 2, waveform 3, waveform 4, waveform 5... waveform 7 (7 traces at most).
Parameter panels locate at the right part of screen, the parameter order from up to down is Parameter 1, Parameter 2,
Parameter 3, Parameter 4... Parameter 7 (displays 7 parameter panels at most); the default order is ECG, SpO
2
, NIBP, RESP,
TEMP, IBP1 and IBP2.
You can allocate the positions of the parameter waveforms and panels. The parameters or waveforms whose positions
are not allocated will not be displayed.
If no corresponding parameter or waveform is displayed, you should perform the following inspections:

Check the connection between the module and lead, cable, sensor, etc.

Enter the Setup window for the corresponding display configuration.
3.7 Using the Main Menu
To enter the main menu by selecting the “Menu” button, most of the monitor’s operations and settings can be perform