Sharp AR-BC320, Service Manual, Page: 176 / 344

AR-BC320 SIMULATION 9 - 22
2. Press the [EXECUTE] key.
Aging is set and the display returns to the simulation main code
entry menu.
∗
The setup contents of this simulation remain unchanged until
the power is turned off. When this simulation is executed, SIM 7-
8 (Warm-up time display setting) is canceled.
(Set content)
∗
The interval time set range is 1 - 999sec. [Default: 3]
∗
The setup contents of this simulation remain unchanged until
the power is turned off. When SIM 7-1 is executed, the setup
contents are canceled.
Copying is performed with the color selected in procedure 1).
When no print color is selected, the operation is made with the all
colors.
The [EXECUTE] key is highlighted. When the adjustment value
entered in procedure 2) and the corresponding voltage is
outputted.
The voltage is outputted for 30sec, then the [EXECUTE] key
returns to the normal display. When the EXECUTE key is pressed
during output of the voltage, the output is stopped and the
[EXECUTE] key returns to the normal display.
[AGING] Jam detection setup
[INTERVAL] Intermittent setup
[MISFEED DISABLE] Jam detection YES/NO setup
[FUSING DISABLE] Fusing operation YES/NO detection
[WARMUP DISABLE] Warm-up saving setup
[DV CHECK DISABLE] Developing tank detection YES/NO
setup
[SHADING DISABLE] Shading saving setup
[CCD GAIN FREE] No setting of CCD gain adjustment
7 -6
Purpose Setting/Operation test/check
Function
(Purpose) Used to set the cycle of intermittent aging.
Item Operation
Operation/
Procedure 1. Enter the interval aging cycle time (sec) with the
10-key pad.
2. Press [OK] key (or B/W Start key, Color Start
key) to set the entered cycle time.
7 -8
Purpose Setting/Operation test/check
Function
(Purpose) Used to set Yes/No of warm-up time display.
Item Operation
Operation/
Procedure Press the [EXECUTE] key to set the warm-up time
display.
When the [EXECUTE] key is pressed, the warm-up
time display setting is executed and the display
returns to the simulation main code entry display.
7 -9
Purpose Setting/Operation test/check
Function
(Purpose) Used to check the image quality and operations of
each color.
Section Others
Item Picture quality
Operation/
Procedure 1. Select the color of image quantity and operation
check with the key.
2. Press the START key.
8
8 -1
Purpose Adjustment/Operation test/check
Function
(Purpose) Used to check and adjust the operations of the
developing bias voltage of each color and the
control circuit.
Section Process
(Photoconductor, developing, transfer, cleaning)
Operation/
Procedure
(
The developing bias output voltage in each of the
following print modes can be adjusted and
checked.)
(Adjustment range)
0 – 585 (Default: See below)
1. Select the color mode with the [K], [C], [M], or [Y]
key.
2. Select the copy mode with the scroll key.
3. Enter the adjustment value with the 10-key pad.
4. Press the [EXECUTE] key.