Sanyo Denki Sanmotion R 3E S, Instruction Manual, Page: 331 / 514

7.17 Fixed monitor display
7-24
7
Di
gita
l O
per
at
or
7.17 Fixed monitor display
The display shows monitoring value in 2 seconds after powering up.
It shows monitoring value set at Group D ID11 “Monitor Display Selection [MONDISP]” in status
display mode.
“
Monitor” to be displayed is the same as parameter ID in monitor display mode, but in the setting
value “00 STATUS servo amplifier status monitor”, the display will be different from the code
display in the monitor mode and will show the amplifier status in the status display mode
(- or
Ξ
).
In the state of alarm occurring, requiring safety function input, requiring motor magnetic pole
detection or detecting the poles, the monitor display prioritize these status over the fixed display.
7.18 Motor code-setting of servo motor used
✔
Check the Applicable motor list at "5.1.3 Servo motor setting" about applicable servo motor
and motor code.
Step
Displayed
character,
number, code
Input button How to operate
1 Push MODE until it displays the left.
2 Display changes and right end LED blinks.
3 Push WR for more than 1 second.
4
Display the motor cord of the servo motor used
with addition and subtraction and the cursor
button.
5 Push WR for more than 1 second.
6 A display changes as the left and it performs.
7
Changes to the display of the left after a normal
end.
8 Turn on the power supply again.
Note)
The servomotor that cannot be combined or used displays the left in
Process 5. In this display, please set up by “Setup Software”.
MODE
▲ ▼
WR/
MODE
▲ ▼
WR/
MODE
▲
▼
WR/
MODE
▲ ▼
WR/