Sanyo Denki Sanmotion R 3E S, Instruction Manual, Page: 320 / 514

7. Digital Operator
7-13
7.5.2 Editing general parameters
For example, method of changing Group9 ID01 “Negative Over Travel Function [R-OT]” from
“0B” to ”00“ is as follows. Also, see next example for GroupC ID04 “Encoder Output Pulse
Division [ENRAT]”.
Editing general parameter GroupC ID04 “Encoder Output Pulse Division [ENRAT]”
For example, method to change from 1/1 to 2/64 is as follows.
Step
Displayed
character,
number, code
Input button How to operate
1
Hold down MODE until the figure left is
displayed.
2
Display changes as left, and right end LED
blinks.
3
Display ID of parameter to be changed by
addition/ subtraction, cursor button.
4 Hold down WR for over a second.
5
“
0b
”
is displayed.
6
Set figure
“
00
”
by addition/ subtraction, cursor
button.
7 Hold down WR for over a second.
8 Press MODE.
9 Display to be switched to the display left.
Step
Displayed
character,
number, code
Input button How to operate
1
Hold down MODE until the figure left is
displayed.
2
Display changes as left, and right end LED
blinks.
3
Display ID of parameter to be changed by
addition/ subtraction, cursor button.
4 Hold down WR for over a second.
5
“
Gr nu
”
is displayed.
6
Hold down MODE for over a second to change
the display to Gr dE. “nu” stands for numerator,
“dE” stands for denominator. Hold down MODE
for over a second to switch between “nu” and
“dE.” Set “Gr dE (denominator)” first.
7 Hold down WR for over a second.
8
Display to be switched, and then rightmost LED
flashes.
When setting dE first, holding down WR displays
the denominator.
The display left shows “1” as dE is set first.
When you set nu first, holding down WR displays
numerator.
9
Set figure “64” (denominator) by addition/
subtraction, cursor button.
10 Hold down WR for over a second.
MODE
▲ ▼
WR/
MODE
▲ ▼
WR/
MODE
▲ ▼
WR/
MODE
▲ ▼
WR/
MODE
▲
▼
WR/
MODE
▲
▼
WR/
MODE
▲
▼
WR/
MODE
▲
▼
WR/
MODE
▲
▼
WR/
MODE
▲
▼
WR/
MODE
▲ ▼
WR/
MODE
▲ ▼
WR/
MODE
▲
▼
WR/