NEC ELECTRA ELITE IPK II, User Manual

Page: 668 / 1190

Document Revision 4C Electra Elite IPK II
2 - 644 ISDN Compatibility

10-03-08 ETU Setup (for PRI PKG Setup) – Dial Sending Mode
Set up and confirm the Basic Configuration data for each DTI-U40 ETU.
0 = Enblock Sending
1 = Overlap Sending (Default)

10-03-09 ETU Setup (for PRI PKG Setup) – Dial Information Element
Set up and confirm the Basic Configuration data for each DTI-U40 ETU. If Overlap Sending is
selected in Program 10-03-08, select either Keypad Facility (0) or Called Party Number (1) for
the dial information element.

10-03-18 ETU Setup (for PRI PKG Setup) – Type of Number
Select the number type for the ISDN circuit.

10-03-19 ETU Setup (for PRI PKG Setup) – Numbering Plan Identification
Select the Numbering Plan used for the ISDN circuit.

10-03-20 ETU Setup (for PRI PKG Setup) – Network Exchange Selection
Select the ISDN protocol for the ISDN circuit.

10-03-21 ETU Setup (for PRI PKG Setup) – PRI Number of Ports
Select the number of ports for the PRI.

10-39-01 Fractional Setup
Enable (1)/Disable (0) the T1/PRI fractional function.

21-12-01 ISDN Calling Party Number Setup for Trunks – Calling Party Number Data
Assign Calling Party Numbers for each trunk (maximum 16 digits per entry).

After the above programming is complete a reset of the BRT(4)-U20 ETU is required.

14-05-01 Trunk Group – Trunk Group Number
Assign trunks to Trunk Groups, also assign the outbound priority for trunks in the group.

21-01-03 System Options for Outgoing Calls – Trunk Interdigit Time (External)
The system waits for this time to expire before placing the call in a talk state (default: 5 seconds).
DID Services for either ISDN – BRI or PRI

22-02-01 Incoming Call Trunk Setup – Incoming Type
Assign the incoming trunk type for each trunk.
0 = Normal (Default) 4 = DIL
1 = VRS (Second dial tone if no VRS installed) 5 = E&M Tie Line
2 = DISA 6 = Delayed DID
3 = DID 7 = ANI/DNIS

22-11-01 DID Translation Number Conversion – Received Number
For each DID Translation Table entry (1~2000), specify the digits received by the system (eight
maximum).