NEC ELECTRA ELITE IPK II, User Manual

Page: 372 / 1190

Document Revision 4C Electra Elite IPK II
2 - 348 Direct Inward System Access (DISA)

25-04-01 VRS/DISA Transfer Ring Group With No Answer/Busy
Set the operating mode of each DISA trunk. This sets what happens to the call when the DISA
caller calls a busy or unanswered extension. The call can either disconnect (0), or transfer to an
alternate ring group destination, In-Skin/External Voice Mail, or Centralized Voice Mail. Default
is 0.
Ring Groups:
1~100
102 = In-Skin/External Voice Mail
103 = Centralized Voice Mail

25-05-01 VRS/DISA Error Message Assignment
Assign the VRS message number to be used as the Automated Attendant error message. For
each VRS/DISA trunk that the VRS answers, enter the VRS message (1~48) the outside caller
hears if they dial incorrectly. If you enter 0 (i.e., no error message), the call reroutes according
to PRG 25-03 and PRG 25-04. For each trunk, you make a separate entry for each Night
Service mode. Default is 0.

25-06-01 VRS/DISA One-Digit Code Attendant Setup – Next Attendant Message Number
Set up single digit dialing through the VRS. This gives VRS callers single-key access to
extensions, the company operator, Department Calling Groups and Voice Mail. For each VRS
message set to answer outside calls (see PRG 25-02 and PRG 25-05), you specify:

The digit the VRS caller dials (0~9,

,
#
). (Keep in mind that if you assign destinations to digits,
outside callers cannot dial system extensions, starting with that digit.

The destination reached (eight digits maximum) when the caller dials the specified digit.
The destination can be an extension, a Department Calling pilot number or the Voice Mail
master number. A one-digit code can be assigned for each Automated Attendant message.
Default is 0 (No Setting)

25-07-01 System Timers for VRS/DISA – VRS/DISA Dial Tone Time
After answering the DISA trunk, the system waits this time (0~64800 seconds) for the caller to
dial the first digit of the password. If the caller fails to dial within this time, the system drops the
call. Default is 10.

25-07-02 System Timers for VRS/DISA – VRS/DISA No Answer Time
A DISA caller can ring an extension for this time (0~64800 seconds) before the system sets the
call as a Ring No Answer. After this time expires, the call follows the programmed Ring No
Answer routing. (Refer to Program 25-04 in the Electra Elite IPK II Programming Manual.)
Default is 0.

25-07-07 System Timers for VRS/DISA – Long Conversation Warning Tone Time
Determine the time a DISA caller or any automatically transferred trunk-to-trunk (such as
Tandem Trunking) conversation can talk before the Long Conversation tone is heard (0~64800
seconds). Default is 3600.

25-07-08 System Timers for VRS/DISA – Long Conversation Disconnect
This determines the time the system waits before disconnecting a a DISA or any automatically
transferred trunk-to-trunk (such as Tandem Trunking) call after the Long Conversation tone is
heard (0~64800 seconds). Default is 10.