NEC ELECTRA ELITE IPK II, User Manual

Page: 222 / 1190

Document Revision 4C Electra Elite IPK II
2 - 198 Central Office Calls, Placing

14-01-07 Basic Trunk Data Setup – Outgoing Calls
For each trunk, allow (1) or prevent (0) outgoing calls.

14-01-10 Basic Trunk Data Setup – DTMF Tones for Outgoing Calls
For each trunk, Enable (1)/Disable (0) an extension user ability to hear the DTMF of the digits
dialed when placing the outgoing call.

14-02-05 Analog Trunk Data Setup – Dial Tone Detection for Manual Accessed Trunks
Enable (1)/Disable (0) dial tone detection for directly accessed trunks. If disabled, the system
outdials on the trunks without monitoring for dial tone.

14-02-11 Analog Trunk Data Setup – Next Trunk in Rotary if No Dial Tone
Enable (1)/Disable (0) the system ability to skip over a trunk if dial tone is not detected. This
option pertains to calls placed using Call Appearance (CAP) Keys, Speed Dial, Automatic Route
Selection (ARS), Last Number Redial or Save Number dialed. It does not pertain to line key or
Direct Trunk Access calls.

14-02-14 Analog Trunk Data Setup – Loop Start/Ground Start
Select loop start (0) or ground start (1) for the trunk.

14-05-01 Trunk Group – Trunk Group Number
Assign trunks to Trunk Groups. You can also assign the outbound priority for trunks in the group.
When a user dials the trunk group, they seize the trunks in the order specified in the outbound
priority entry.
Trunks: 1~200
Trunk Groups: 1~100

At default, all group are assigned to Trunk Group 1.

14-06-01 Trunk Group Routing
Set up an outbound routing table for the trunk groups you assigned in Program 14-05-01. When
a user dials 9, the system routes the calls in the order (priority) specified.
Trunk Routing Table: 1~100

14-07-01 Trunk Access Map Setup
Set up the Trunk Access Maps. This sets the access options for trunks.
Trunk Access Maps: 1~200