NEC ELECTRA ELITE IPK II, User Manual

Page: 432 / 1190

Document Revision 4C Electra Elite IPK II
2 - 408 D
term
IP Gateway System
S
OFTWARE
S
UPPORT

TCP/IP protocol supports IP traffic and management.

RVPoIP uses UDP/IP protocol for voice transmission.

Serial RVP uses HDLC encapsulation for voice transmission.

Management and utilities include Telnet, inband RVP, RS-232 console interface (Gateway and
Branch), SNMP, and HTML.

Software upgradable, using FTP, between the Gateway and the branch, RS-232 serial port to PC,
or inband connection.
Conditions

Refer to D
term
IP Gateway System Administrator’s Guide or D
term
IP Gateway II System
Administrator’s Guide for more information.

TAPI is not supported.

When you dial 911 on your D
term
telephone, the 911 facility reached is the one that serves
the Gateway facility. To reach the correct 911 service for your area, use a telephone
connected locally. The
D
term
IP Branch unit provides an analog port for local dialing.

Synchronous ringing does not work on the remote telephone. Incoming trunk calls
automatically ring two seconds on/two seconds off.

Analog Fax machines and modems cannot operate with a D
term
Multiline Terminal that is
connected to an APR-U Unit or AP(A)-R Unit optional adapter.

The CT(A)-R Unit, CTA-U Unit, or CTU(S)-U Unit cannot be installed to a KTS remote
Multiline Terminal to provide TAPI functionality with the KTS.

The DTP-32DE-1 Multiline Terminal is the only one certified for use in a home environment.
None of the other
D
term
Series E or Electra Elite Multiline Terminals are certified for home
use because of FCC restrictions, but they are approved for use in an office environment.

The HFU-U/HF-R Unit handsfree adapter cannot operate with a KTS remote Multiline
Terminal for home use because of FCC restrictions, but it is approved for use in an office
environment.

An applicable network terminating device must be installed and functioning at both the
corporate facility and the branch office.

The data connection between the corporate facility and the branch office must be
configured properly and operational.

Network termination equipment must support an RS-232, V.35 or RS-530 synchronous
interface or support IP devices over Ethernet.

The system operates from 100-240 VAC, 50-60 Hz. Power must not be applied to the
Gateway unit until specified in the installation procedures.