NEC ELECTRA ELITE IPK II, User Manual

Page: 987 / 1190

Electra Elite IPK II Document Revision 4C
Tandem Trunking (Unsupervised Conference) 2 - 963
To end the Tandem Call:
1. Press either flashing line key.

The line keys light steadily (green). You can listen (i.e., monitor) to the call or rejoin the conversation, based on
the setting in Program 20-13-10.
2. Press Speaker or hang up.

If Program 20-13-10 is set to 0, the Conference ends and the line keys go out.

If Program 20-13-10 is set to 1, to manually disconnect the Conference, Forced Trunk Disconnect (i.e., Press the
line key +

3 or the service code set of Forced Trunk Disconnect in PRG 11-10-26) must be used by an extension
other than the originating extension.
Method B – Tandem Trunking with Transfer Key
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press Hold to place the first trunk call on hold.
3. Place a second trunk call.
4. Press Transfer .

This sets up an Unsupervised Conference with both outside parties.

The line keys for the trunks light solid red.

To disconnect the Conference, use Forced Trunk Disconnect (i.e., Press the line key +

3 or the service code set
of Forced Trunk Disconnect in PRG 11-10-26) must be used by an extension other than the originating
extension.
Single Line Telephone
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press hookflash and dial
#
1 .
3. Place or answer second trunk call.
4. To set up the tandem call, press hookflash and dial
#
8 .
5. Hang up.

This sets up a Conference between both outside parties.
Method C – Tandem Trunking on Hang up
To set up a Tandem Call:
1. Place or answer first trunk call.