NEC ELECTRA ELITE IPK II, User Manual

Page: 696 / 1190

Document Revision 4C Electra Elite IPK II
2 - 672 K-CCIS – T1

Centralized E911 – K-CCIS is supported.

When Centralized E911 – K-CCIS is not used, each Electra Elite IPK II system in a K-CCIS
network must have at least one trunk for Emergency 911 calls.

Using a NEAX-to-Electra Elite IPK II network, the PBX must supply centralized voice mail.

Multiline terminals must have an available Call Appearance (CAP) key to originate or
answer a K-CCIS trunk call.

Direct access of K-CCIS voice or data channels using Line keys or Specified Line Seizure
access codes is prohibited.

The Recall key or Drop key does not function on K-CCIS calls. When either key is pressed,
operation is ignored, and the call continues.

Trunk queuing is prohibited on a K-CCIS trunk route.

Routing an incoming DID call directly across a K-CCIS link (Direct Inward Dialing
-
K-CCIS)
is supported only when a Closed Numbering Plan using F-Routes is used.

This feature is not supported by the TLI(2)-U( ) Analog Line interface.

Only one CCH(4)-U( ) ETU can be assigned per system.

Extension numbers cannot start with 0 or 9.

Internal Calls, transferred calls, and K-CCIS calls do not provide Caller ID to single line
telephones.

Caller ID Call Return feature is not supported with K-CCIS calls.

Call Park Searching is supported only in the local system.

With Version 1600 or higher , a remote K-CCIS user can call, or transfer a call directly to
an ACD Pilot number. However, an incoming K-CCIS call to the ACD Pilot number does
NOT provide a Link Reconnect.

When the system searches the Dial Extension Analyze Table (PRG 11-20-01), the system
uses prefix searching, giving the lower table number the higher priority. For example, the
user programs 211 in table 1 and 2113 in table 2, then dials 2113, the system selects table
1.

Program 11-01-01 9: System Numbering – Dial Extension Analyze is not supported in
Version 1600 .

Program 11-20-01: Dial Extension Analyze Table – Dial and Program 11-20-02: Dial
Extension Analyze Table – Type of Dials are not supported in
Version 1600 .
Default Setting
Not installed