NEC ELECTRA ELITE IPK II, User Manual

Page: 153 / 1190

Electra Elite IPK II Document Revision 4C
Call Forwarding – Centrex 2 - 129
Programming

10-09-01 DTMF and Dial Tone Circuit Setup
Allocate the circuits on the CPUII ETUs for either DTMF receiving or dial tone detection. PRG
14-01-13 Basic Trunk Data Setup – Loop Supervision. Enable (1) loop supervision for each
trunk that should be able to use Call Forwarding – Centrex.

11-11-45 Service Code Setup (for Setup/Entry Operation) – Set/Cancel Call Forward All (Split)
Assign the Call Forward All Split Service Code (default not assigned).

11-11-46 Service Code Setup (for Setup/Entry Operation) – Set/Cancel Call Forward Busy (Split)
Assign the Call Forward Busy Split Service Code (default not assigned).

11-11-47 Service Code Setup (for Setup/Entry Operation) – Set/Cancel Call Forward No Answer
(Split)
Assign the Call Forward No Answer Split Service Code (default not assigned).

11-11-48 Service Code Setup (for Setup/Entry Operation) – Set/Cancel Call Forward Busy/No
Answer (Split)
Assign the Call Forward Busy No Answer Split Service Code (default not assigned).

14-04-01 Behind PBX Setup – Type of Connection
Indicate if the trunk is installed behind a PBX (1) or not (0). There is one item for each Night
Service Mode.

20-09-01 Class of Service Options (Incoming Call Service) – Second Call for DID/DISA/DIL/E&M
Override
Turn off or on an extension ability to receive a second call from a DID, DISA, DIL, or tie line
caller.

20-09-07 Class of Service Options (Incoming Call Service) – Call Queuing
Turn off or on an extension user ability to have calls queued if a call rings the extension when it
is busy.

20-13-05 Class of Service Options (Supplementary Service) – Intercom Off-Hook Signaling
Turn off or on an extension ability to receive Off-Hook signals.

20-13-06 Class of Service Options (Supplementary Service) – Automatic Off-Hook Signaling
(Automatic Override)
Allow a busy extension user ability to manually (0) or automatically (1) receive Off-Hook signals.

24-02-13 System Options for Transfer – Hook Flash Sending Timer When the System Answers
Automatically (Version 1600 and 2100 or higher required)
Set the time the system waits before sending the hookflash for the Centrex Transfer after
answering the call.
0~64800 (sec) (default: 2)

24-09-06 Call Forward Split Settings – Call Forwarding Destination for CTX/PBX for All Call, No
Answer (Version 1500 or higher required)
0~9, # ,

, P, R, @ (up to 24 digits)