NEC ELECTRA ELITE IPK II, User Manual

Page: 428 / 1190

Document Revision 4C Electra Elite IPK II
2 - 404 D
term
Handset Cordless
To change the Auto Talk mode:
1. Hold down Trf key while changing the Ringer On/Off switch from Off to On.
2. When the mode changes, a confirmation tone is generated:
Auto Talk Off: 3 Beeps
Auto Talk On: 2 Beeps
Answering calls:
1. When the Handset is on the Base Unit, only the Base Unit rings and the Large LED flashes as
usual.
2. When in Standby mode, the handset and Base Unit both ring and the message waiting LED
flashes rapidly in conjunction with the Base Unit Talk/Batt.low LED.

When Ringer On/Off switch is in Off mode, the Handset does not ring, but the message waiting LED flashes.
With Auto Talk off:
1. When the Handset is on the Base Unit, lift it and press any key.
2. The Talk/Batt.low LED flashes then lights continuously to indicate established communication path
between the Handset and the Base Unit.
3. Talk to the caller. The Message waiting LED is Off.
4. When finished, press the Talk key or place Handset back in the Base Unit to disconnect the call.
With Auto Talk On:
1. When the Handset is on the Base Unit, lift it.
2. The Talk/Batt.low LED flashes then lights continuously to indicate established communication path
between the Handset and the Base station.
3. Talk to the caller. The Message waiting LED is Off.
4. When finished, press the Talk key or place Handset back in the Base Unit to disconnect the call.
5. In Auto Standby, the Talk key does not have to be pressed to disconnect. Place the Handset in the
Base Unit to disconnect the call.
6. After call is disconnected the Message Waiting LED becomes active again when messages are
waiting.
Setting handset ringer On/Off Volume in Standby Mode:
1. Press Vol key to adjust volume normal or high.
2. While Vol is pressed, the ringer starts to ring based on the current setting.

Ringer Volume can be adjusted with Ringer On/Off key in Off.