NEC ELECTRA ELITE IPK II, User Manual

Page: 1021 / 1190

Electra Elite IPK II Document Revision 4C
Trunk Groups 2 - 997

14-02-11 Analog Trunk Data Setup – Next Trunk in Rotary if No Dial Tone
Enable (1)/Disable (0) the system ability to skip over a trunk if dial tone is not detected. This
pertains to calls using Call Appearance (CAP) Keys, Speed Dial, ARS, Last Number Redial, or
Save Number Dialed. It does not pertain to line keys or Direct Trunk Access calls.
(default: 0)

14-05-01 Trunk Group – Trunk Group Number
Assign trunks to trunk groups.
Trunk Groups: 1~200
(default: All trunks Assigned to Trunk Group 1)

14-06-01 Trunk Group Routing – Priority Order Number
Set up an outbound routing table for trunk groups assigned in Program 14-05.
Trunk Group Routes: 1~100
Default:
Route 1, Order Number 1 = 1 (Trunk Group 1)
Order Numbers 2~4 = 0 (Not Specified)
All other Routes (2~100) and Order Numbers (1~4) = 0 (Not Specified)

14-07-01 Trunk Access Map Setup – Trunk Port Number
Access Map programming may limit Trunk Group Routing options.
Trunk Access Maps: 1~200
Default:
Access Map 1 = Trunk Ports 1~200 assigned with Option 7 (Incoming, Outgoing, and Trunk on
Hold access).
Access Maps 2-~200, Trunk Ports 1~200 assigned Option 0 (No Access)

15-06-01 Trunk Access Map for Extensions
Assign Access Maps to extensions.
Trunk Access Maps: 1~200
(default: 1)

15-07-01 Programmable Function Keys
Assign function keys for trunk group access (code

02 + group) or Call Appearance (CAP) Keys
(code

08 + CAP Key orbit 0001~9999 (or 0000 for auto assign).
Trunk Groups: 1~100

20-02-02 System Options for Multiline Telephones – Trunk Group Access Key Operating Mode
Set the operating mode of the extension trunk group keys.
Operating Modes:
Incoming and Outgoing Access = 0
Outgoing Access = 1
Incoming Access = 2
(default: 0)

21-01-02 System Options for Outgoing Calls – Intercom Interdigit Time
When placing intercom calls, an extension user must dial each digit in this time (0~64800
seconds).
(default: 10)