NEC ELECTRA ELITE IPK II, User Manual

Page: 1008 / 1190

Document Revision 4C Electra Elite IPK II
2 - 984 Transfer

15-02-24 Multiline Telephone Basic Data Setup – Conference Key Mode
Program an extension Conf key for Conference or for Transfer. When set for Transfer (1), the
user places a call on hold, dials the extension to which it should be transferred, then presses the
Conf key. The call is then transferred. When set for Conference (0), with an active call, the user
presses the Conf key, places a second call, then presses the Conf key twice. All the calls are
then connected.
(default: 0)

20-02-04 System Options for Multiline Telephones – Retrieve the Line After Transfer
Enable (1)/Disable (0) an extension user ability to answer a call after it has been transferred, but
before it is answered.
(default:1)

20-03-01 System Options for Single Line Telephones – SLT Call Waiting Answer Mode
For a busy single line (500/2500 type) telephones, set the mode used to answer a camped-on
trunk call.
Modes:
0 = Press and release hookswitch to pick up waiting call
1 = Press and release hookswitch and dial Service Code 794 (Call Waiting Answer/Split Answer
for SLT) to answer waiting call.
(default: 0)

24-02-02 System Options for Transfer – MOH or Ringback on Transferred Calls
Enable (1)/Disable (0) MOH on Transfer. If enabled (0), a transferred caller hears Music on Hold
while their call rings the destination extension. If disabled (1), a transferred caller hears ringback
while their call rings the destination extension. For this option to work with voice mail, the
transferred call must be an unscreened transfer.
(default: 0)

20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to extensions.

20-11-06 Class of Service Options (Hold/Transfer Service) – Unscreened Transfer (Ring Inward
Transfer)
Enable (1)/Disable (0) the ability to use Unscreened Transfer.
(default: 1)

20-11-07 Class of Service Options (Hold/Transfer Service) – Transfer Without Holding
Enable (1)/Disable (0) the ability to use Transfer Without Holding.
(default: 0)

20-11-08 Class of Service Options (Hold/Transfer Service) – Transfer Information Display
Enable (1)/Disable (0) the incoming Transfer pre-answer display.
(default: 1)

20-11-11 Class of Service Options (Hold/Transfer Service) – Automatic On-Hook Transfer
Enable (1)/Disable (0) the ability to use Automatic On-Hook Transfer. If enabled, user must
press Hold and dial the extension number to Transfer the call. If disabled, a user must have a
Transfer Programmable Function Key. To transfer the call, the user would press Hold, dial the
extension number, then press the Transfer Programmable Function key to complete the
transfer.
(default: 0)