NEC ELECTRA ELITE IPK II, User Manual

Page: 112 / 1190

Document Revision 4C Electra Elite IPK II
2 - 88 Automatic Route Selection
Speed Dial – System/Group/Station
Trunk Group Routing
Trunk Queuing/Camp On
Programming

11-01-01 System Numbering
Set the system internal (Intercom) numbering plan. The numbering plan assigns the first and
second digits dialed and affects the digits an extension user must dial to access other
extensions and features, such as service codes and trunk codes. If the default numbering plan
does not meet the site requirements, use this program to tailor the system numbering to the site.

11-09-01 Trunk Access Code
Specify the single digit code used to access ARS (normally 9).

14-05-01 Trunk Group – Trunk Group Number
Program trunks of the same carrier type into the same trunk group.

14-07-01 Trunk Access Map Setup
Set up the Trunk Access Maps. This sets the access options for trunks
Trunk Access Maps: 1~200

15-06-01 Trunk Access Map for Extensions
Assign Trunk Access Maps to extensions.
Trunk Access Maps: 1~200

20-03-04 System Options for Single Line Telephones – Dial Sending Start Time for SLT or ARS
When ARS or an analog extension user accesses a trunk and dials an outside call, the system
waits this interval before outdialing the first digit (0~64800 seconds).

20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.

20-08-17 Class of Service Options (Outgoing Call Service) – ARS Override of Trunk Access Map
Enable (1)/Disable (0) an extension user ability to override the trunk access map programming
(Program 14-07-01 and Program 15-06-01) for outgoing calls.

26-01-01 Automatic Route Selection Service – ARS Service
Enable (1)/Disable (0) ARS.

26-01-02 Automatic Route Selection Service – Network Outgoing Inter-Digit ARS Timer
With Networking, this timer (0~64800 msec.) replaces PRG 20-03-04 when determining if all
network protocol digits are received. If ARS is enabled at Site B, this timer can be programmed
for 5 (500 msec) at Site A. If ARS is disabled and Site B is using F-Route for outbound dialing,
this timer should be programmed for 30 (3 seconds) at Site A.