NEC ELECTRA ELITE IPK II, User Manual

Page: 259 / 1190

Electra Elite IPK II Document Revision 4C
Code Restriction 2 - 235

15-02-30 Multiline Telephone Basic Data Setup – Toll Restriction Class

20-06-01 Class of Service for Extensions
For each extension, assign a Class of Service (1~15).

20-08-02 Class of Service Options (Outgoing Call Service) – Trunk Outgoing Calls
For each Class of Service, Enable (1)/Disable (0) an extension user ability to place an outgoing
trunk call.

20-13-20 Class of Service Options (Supplementary Service) – Account Code/Toll Restriction
Operator Alert (Restricted Operation Transfer)
When toll restriction is violated, determine if the operator should be notified.
Operator Alert:
0 = Disable
1 = Enable

21-01-10 System Options for Outgoing Calls – Dial Digits for Toll Restriction Path
If this option is set an entry other than 0, a call does not have a talk path unless the user dials at
least the number of digits entered in this option when placing an outgoing call. This means an
entry of 4 or higher in this program causes a problem when dialing 911. Since it is only a 3-digit
number, the call does not have a talk path, preventing the emergency dispatcher from hearing
the caller. This option should be kept at its default setting of 0 to prevent any problems with
dialing 911. If the system detects the call is answered, by detecting Reversal in analog trunks,
this restores both-way voice paths immediately.

21-01-15 System Options for Outgoing Calls – Outgoing Disable on Incoming Line (Toll
Restriction)
Enable (1)/Disable (0) the Outgoing Disable on Incoming Line feature.

21-01-16 System Options for Outgoing Calls – Supervise Dial Detection Timer
With the Outgoing Disable on Incoming Line feature, if dial tone is not detected after the
extension answers an incoming line, the system determines the call cannot complete and
releases the DTMF receiver (0~64800 seconds).

21-01-17 System Options for Outgoing Calls – Restriction Digit in Outgoing Disable on Incoming
Line
With the Outgoing Disable on Incoming Line feature, determine the number of digits (0~9) to be
dialed before the call should be disconnected.

21-04-01 Toll Restriction Class for Extensions
For each extension, assign a Toll Restriction Class for each Night Service mode.

21-05-01 Toll Restriction Class – International Call Restriction Table
For the Toll Restriction Class you select, Enable (1)/Disable (0)) the International Call Restrict
Table (Program 21-06-01).

21-05-02 Toll Restriction Class – International Call Permit Code Table
For the Toll Restriction Class you select, Enable (1)/Disable (0) the International Call Permit
Table (Program 21-06-02).