NEC ELECTRA ELITE IPK II, User Manual

Page: 1149 / 1190

Electra Elite IPK II Document Revision 4C
Codes Tables 3 - 5
#
8 Set up an Unsupervised
Conference Tandem Trunking
(Unsupervised
Conference)
-
#
9 + 001 -200 Place a call over a specific trunk Central Office Calls,
Placing

01 + trunk
(001~200)
0 (Off-Hook) Leave a Message Waiting at a co-
worker’s busy or unanswered
extension Message Waiting 35
1 (Off-Hook) Change the signaling mode of your
outgoing Intercom call Handsfree
Answerback/Forced
Intercom Ringing
-
4 (On-Hook) Listen to the General Message Voice Response System
(VRS)
-
6 (On-Hook) Check an extension number Voice Response System
(VRS)
-
8 (On-Hook) Listen for the time Voice Response System
(VRS)
-
9 Place a call using ARS or Trunk
Group Routing Automatic Route
Selection
Trunk Group Routing

02
100 + code + 0 Use Dial Block Toll Restriction, Dial
Block
-
101 + code + 0 Are a supervisor using Dial Block Toll Restriction, Dial
Block
-
+ Group number
(1~8 or 01~64)
Set Automatic Transfer Setup for
each extension group Transfer -
102 + Group number
(1~8 or 01~64)
Cancel Automatic Transfer Setup Transfer -
103 + Group number
(1~8 or 01~64) + mode +
extension
Set the destination for Automatic
Transfer Setup for each extension
group Transfer -
104 + Group number
(1~8 or 01~64)
Set Delayed Transfer for each
extension group Transfer -
105 + Group number
(1~8 or 01~64)
Cancel Delayed Transfer Transfer -
106 + Group number
(1~8 or 01~64)
Set up DND for each extension
group Transfer -
Table 3-2 Service Codes by Number (Continued)
Dial this Service Code. . .
1
When you. . . For this feature. . .
Also see
Function Key. . .
1
Except where indicated, dial Service Code from Intercom dial tone (e.g., press idle Speaker key first).