®
Thank you for purchasing the MegaRAID
®
SCSI 320-2X
RAID Controller. Please take a few minutes to read this quick
installation guide before you install the controller. If you need
more information about any topic covered in this guide, refer
to the other documents on your MegaRAID Universal
Software Suite CD.
Note:
The BBU03 Battery Backup Unit (BBU) and the
TBBU03 Transportable Battery Backup Unit
(TBBU) can be used with the MegaRAID 320-2X.
For more information about battery backups, refer
to the MegaRAID Battery Backup Unit User’s
Guide on the MegaRAID Universal Software
Suite CD.
M e g a R A I D 3 2 0 - 2 X R A I D C O N T R O L L E R
I N S T A L L A T I O N
Step 1
Unpack the Controller.
Unpack the controller in a static-free environment.
Remove it from the antistatic bag and inspect it
for damage.
If the controller appears to be damaged, or if the
MegaRAID Universal Software Suite CD is
missing, contact LSI Logic or your MegaRAID
OEM support representative.
Back up your data before you change your system
configuration. Otherwise, you may lose data.
The MegaRAID Universal Software Suite CD is
packaged with the MegaRAID 320-2X. The CD
contains utility programs, device drivers for
various operating systems, and the following
documentation:
•
MegaRAID 320 Storage Adapters User’s Guide
•
MegaRAID Configuration Software User’s Guide
•
MegaRAID Device Driver Installation User’s Guide
•
Software license agreement
Follow these steps to install the MegaRAID 320-2X.
Step 2
Prepare the Computer.
Turn off the computer and unplug the power
cord(s) from the back of the power supply.
Remove the cover from the chassis.
Step 3
Review the Jumpers and Connectors.
shows the location of the jumpers and
connectors on the MegaRAID 320-2X. The
jumpers are set at the factory and you usually do
not need to change them.
Figure 1 MegaRAID 320-2X Board Layout
!
CAUTION
J2
J1
J17
J18
J11
J13
J14
J7
J6
U6
J12
J19
J5
MegaRAID
®
SCSI 320-2X
RAID Controller
Quick Installation Guide
