Chapter 3
Page no. 272
Indicators and Switches.fm
GE Healthcare
Senographe DS
Revision 1
Service Information and Procedures Class A 2385072-16-8EN
Central Listing
2-7-3.
Supply Command Board 200PL2 Neon Lights
2-7-4.
Supply Command Board 200PL2 Fuses
DE3
Heater Meter at Maximum Limit
Red
Normal status: OFF
ON when the heater meter has reached the maxi-
mum value. This is normal after some important
stop/starts. In this case cut the power to the Gener-
ator and power it back up. If the DE3 LED system-
atically is on after restarting the Generator, replace
the Supply Command Board 200PL2.
OFF when the heater meter is operating normally
and has not reached its maximum limit.
LED
Function
Color
Behavior
N1
250 V from the Transformer present
Orange Normal status: ON
ON when the 250 V supply from the Generator
Transformer is present.
OFF when 250 V supply from the Generator Trans-
former is not present. In this case, proceed as fol-
lows:
• Check the F6 fuse, and change if necessary.
• Check the status of the N1 and N2 neon lights on
the Mains Distribution Board 200PL1.
If N1 and N2 are ON there is a problem with either
the Generator Transformer or the cabling of the
Generator Transformer. Check the cabling within
the Generator Transformer and on the K1 contact
and XJ10 connector.
If N1 is OFF and N2 is ON there is possibly a
problem with the X1 relay on the Mains Distribu-
tion Board 200PL1, and you must change the
Mains Distribution Board 200PL1.
Fuse
Specification
PN
Function
F1
250 Vac, 3.15 A, Delay
99194288
3.15 A / 250 V (+27 V X-ray Console)
F2
250 Vac, 0.5 A, Delay
58079685
0.5 A / 250 V +27 V fan)
F3
150 Vac, 125 A, Fast
91684676
125 A/150 V (27 V AC)
F4
380 Vac, 10 A, Fast
58079166
10 A/380 V (starter, 250 V)
F5
10 A/380 V (heater, BT supply, 250 V)
F6
250 Vac, 16 A, Fast
58079690
16 A/250 V (250 V AC)
