Fagor 8065, Error Solving Manual

Page: 71 / 220

Error solving manual.
CNC 8060
CNC 8065
·71·
(R
EF
: 1709)
1616 'G31 does not allow programming the polar radius'
DETECTION During execution.
CAUSE A Polar radius has been defined for function G31.
SOLUTION Function G31 does not allow programming the Polar radius. Function G31 only admits
Polar coordinates like G31 Q I J; i.e. programming the angle and one or both center
coordinates.
1617 'Q index not allowed'
DETECTION During execution.
CAUSE The index of parameter Q is wrong; it only admits Q or Q1.
SOLUTION Check the program. When programming in Polar coordinates, use parameter Q. For
function G33, use parameter Q1.
1618 'Q value programmed twice'
DETECTION During execution.
CAUSE The Q parameter has been programmed more than once in the same block.
SOLUTION Check the program.
1619 'Q1 value programmed twice'
DETECTION During execution.
CAUSE The Q1 parameter has been programmed more than once in the same block.
SOLUTION Check the program.
1620 '#SERVO ON not admitted for POSITION-SERCOS axis or spindle'
DETECTION During execution.
CAUSE Axis or spindle is position Sercos.
SOLUTION This instruction only admits velocity-Sercos axes.
1621 'Q1 not admitted without G33 in the block or G32 active'
DETECTION During execution.
CAUSE A parameter Q1 has been programmed without G33 in the block or without function
G63 being active'
SOLUTION Parameter Q must go in the same block as G33. Parameter Q can only go alone in
the block if function G63 is active.
1622 'A temporary-exchange spindle cannot work as maintained C axis'
DETECTION During execution.
CAUSE The CNC can activate a temporary-exchange spindle as maintained C axis
(parameter PERCAX).
SOLUTION If possible, define the spindle as maintained exchange; otherwise, use another
spindle as C axis.
1623 'Invalid set for synchronization SYNCSET'
DETECTION During execution.
CAUSE Parameter SYNCSET has the wrong value.
SOLUTION Assign a correct value to the parameter.
1624 'Program #TANGCTRL ON/OFF/SUSP [ ]'
DETECTION During execution.
CAUSE The syntax of the instruction is wrong or there is more data in the block.
SOLUTION Check the program. Together with the instruction, program one of the commands
ON/SUSP/OFF and then the call parameters between square brackets. It is also
possible to program one of the SUSP/OFF commands without call parameters.
1625 'An axis in active tangential control must be rotary, non-HIRTH and it must not belong to
the active trihedron'
DETECTION During execution.
CAUSE The axes to activate in tangential control must be rotary, not hirth and must not belong
to the active trihedron nor be the longitudinal axis.
SOLUTION Check the program.