Fagor 8065, Error Solving Manual

Page: 106 / 220

Error solving manual.
CNC 8060
CNC 8065
·106·
(R
EF
: 1709)
2129 'Error in the RTCP transformation'
DETECTION During execution.
CAUSE An RTCP transformation has been programmed, but the channel does not have all
the necessary axes.
SOLUTION Before activating the RTCP transformation, configure the channel with all the
necessary axes.
2130 'Error in the inclined plane transformation'
DETECTION During execution.
CAUSE An inclined plane has been programmed and the channel does not have three axes.
SOLUTION Before activating the inclined plane, configure the channel with all the necessary
axes.
2131 'Internal error in C axis mode'
DETECTION During execution.
CAUSE C axis transformation not possible for the block.
SOLUTION Eliminate the block or blocks that caused the error.
2133 'Master axis missing'
DETECTION During execution.
CAUSE The master axis of the coupling is not available in the channel.
SOLUTION Program the coupling with axes from the channel.
2134 'Slave axis missing'
DETECTION During execution.
CAUSE The slave axis of the coupling is not available in the channel.
SOLUTION Program the coupling with axes from the channel.
2135 'Zero maximum spindle speed programmed'
DETECTION During execution.
CAUSE In constant surface speed mode, the maximum spindle speed has not been
programmed.
SOLUTION Program the maximum rpm of the spindle.
2136 'Zero maximum cutting speed programmed'
DETECTION During execution.
CAUSE In constant surface speed mode, the cutting speed has not been programmed.
SOLUTION Program the cutting speed.
2137 'FACEAXIS has not been defined'
DETECTION During execution.
CAUSE No face axis has been defined.
SOLUTION Set machine parameter FACEAXIS = TRUE for the face axis.
2138 'Threading axis missing'
DETECTION During execution.
CAUSE The threading axis is not in the channel.
SOLUTION Program the threading operation with the available axes or configure the axes of the
channel in order to be able to make the thread.
2139 'Threading movement not programmed'
DETECTION During execution.
CAUSE No movement has been programmed for the threading axis.
SOLUTION Program the movement for the threading axis.
2140 'Wrong parameter in programming instruction #SLOPE'
DETECTION During execution.
CAUSE A parameter of the programming instruction #SLOPE is wrong.
SOLUTION Check the correct format in the programming manual.
2141 'Circular path not allowed (less than 2 axes)'
DETECTION During execution.
CAUSE Circular paths are not possible if there aren't at least two axes in the channel.
SOLUTION Configure the channel with at least two axes.