Error solving manual.
CNC 8060
CNC 8065
·119·
(R
EF
: 1709)
2425
#PLC[PLCmark=0/1,PLCmark=0/1,...]
DETECTION
During editing and execution.
CAUSE
The syntax of the instruction is wrong.
SOLUTION
Check the syntax of the instruction in the programming manual.
2426
#PLC: non-modifiable mark.
DETECTION
During editing and execution.
CAUSE
The mark programmed in the #PLC instruction is not modifiable.
SOLUTION
The instruction #PLC can only activate or deactivate modifiable tags.
2427
#DMC ON[<PWRSP value><,OVRMIN value><,OVRMAX value><,FZMIN value><,FZMAX
value>]
DETECTION
During editing and execution.
CAUSE
The syntax of the instruction is wrong.
SOLUTION
Check the syntax of the instruction in the programming manual.
2428
#DMC OFF
DETECTION
During editing and execution.
CAUSE
The syntax of the instruction is wrong.
SOLUTION
Check the syntax of the instruction in the programming manual.
2429
Parameter DMC out of range
DETECTION
During editing and execution.
CAUSE
A command in the instruction #DMC has an invalid value.
SOLUTION
Check the syntax of the instruction in the programming manual.
2430
#DMC ON: FZMIN must be less than FZMAX.
DETECTION
During execution.
CAUSE
For the function #DMC, the minimum feedrate is greater than the maximum feedrate.
SOLUTION
The minimum feedrate (FZMIN) must be less than the maximum feedrate (FZMAX).
2431
#DMC ON: OVRMIN must be less than OVRMAX.
DETECTION
During execution.
CAUSE
For the function #DMC, the minimum override is greater than the maximum override.
SOLUTION
The minimum override (OVRMIN) must be less than the maximum override
(OVRMAX).
2432
#DMC ON: Programming not allowed with analog spindle.
DETECTION
During execution.
CAUSE
The CNC has attempted to activate DMC on an analog spindle.
SOLUTION
DMC can only be activated on digital spindles.
2433
ON/OFF must be programmed.
DETECTION
During execution.
CAUSE
The command ON/OFF is not programmed to activate or deactivate the function.
SOLUTION
Check the syntax of the instruction in the programming manual. Include the command
ON to activate the function (for example, #DMC ON [...]) or the OFF command to
cancel it (for example, #DMC OFF).
2438
#LEAP [GAP] XY without previously programming #GAPCTRL ON.
DETECTION
During block preparation.
CAUSE
A leap has been programmed using the command #LEAP, which must finish at a
certain distance along the plate (GAP parameter). The command #GAPCTRL ON is
not programmed. It may be that the GAP parameter is not programmed for the block
where the error occurs, but rather a previous #LEAP.
SOLUTION
The possible solutions are:
• Program #GAPCTRL ON before the #LEAP where error is detected
• Remove the parameter GAP from the #LEAP commands.
Summary of Contents for 8065
