Error solving manual.
CNC 8060
CNC 8065
·134·
(R
EF
: 1709)
3702
'Axis following error out of limit'
DETECTION
During execution.
CAUSE
The axis has exceeded the admitted amount of following error set by machine
parameters. It may be because the axis has not been adjusted properly, because the
axis has not been enabled, because there has been a failure at the motor, at the drive,
in the feedback system and/or in the mechanics.
SOLUTION
Check the machine parameters, the axis adjustment, the connections, the status of
the drive and motor-feedback system.
3703
'Positive software travel limit overrun'
DETECTION
During the movement of the axis.
CAUSE
The axis has exceed the position value set by machine parameter LIMIT+ or by the
V.A.RTPOSLIMIT.xn variable.
SOLUTION
Check the program.
3704
'Negative software travel limit overrun'
DETECTION
During the movement of the axis.
CAUSE
The axis has exceed the position value set by machine parameter LIMIT- or by the
V.A.RTNEGLIMIT.xn variable.
SOLUTION
Check the program.
3705
'Home search required'
DETECTION
During execution.
CAUSE
The CNC has lost the spindle reference (home) when switching from open loop to
closed loop.
SOLUTION
Contact your supplier.
3706
'Error when operating with a probe'
DETECTION
During probe initialization.
CAUSE
The digital input assigned to the probe is not valid.
SOLUTION
Check the probe parameters.
3707
'Error when searching home'
DETECTION
During home search.
CAUSE
Error in the home search process. It may be because the axis parameters have not
been properly set, because there has been a failure at the counter module, at the
Sercos drive, in the feedback system or due to a connection error.
SOLUTION
Check the parameters related with home search, status of the counter module or
Sercos drive, feedback system or the connections.
3708
'Maximum time to get into the in-position zone exceeded'
DETECTION
During execution.
CAUSE
The time the axis needs to get into the in-position zone so the CNC considers it to
be in position, exceeds the value set in parameter INPOMAX.
SOLUTION
Adjust parameter INPOMAX.
3709
'Error when refreshing analog inputs'
DETECTION
When reading analog inputs.
CAUSE
Failure in the cyclic reading process for analog intputs. This may be due to problems
in the COMPCI, CAN bus, analog input module, etc.
SOLUTION
Check the status of the CAN bus, analog input modules, connections, etc.
3710
'Position command values out of range'
DETECTION
During execution.
CAUSE
Overflow at the position command variable.
SOLUTION
Check the settings of the axis parameters.
Summary of Contents for 8065
