Fagor 8065, Error Solving Manual

Page: 175 / 220

Error solving manual.
CNC 8060
CNC 8065
·175·
(R
EF
: 1709)
8236 '"V" programmed twice'
DETECTION During editing.
CAUSE The V axis has been programmed more than once in the block.
SOLUTION Program the V axis only once in the block.
8237 '"W" programmed twice'
DETECTION During editing.
CAUSE The W axis has been programmed more than once in the block.
SOLUTION Program the W axis only once in the block.
8238 '"X" programmed twice'
DETECTION During editing.
CAUSE The X axis has been programmed more than once in the block.
SOLUTION Program the X axis only once in the block.
8239 '"Y" programmed twice'
DETECTION During editing.
CAUSE The Y axis has been programmed more than once in the block.
SOLUTION Program the Y axis only once in the block.
8240 '"Z" programmed twice'
DETECTION During editing.
CAUSE The Z axis has been programmed more than once in the block.
SOLUTION Program the Z axis only once in the block.
8241 'Parameter out of range'
DETECTION During execution.
CAUSE The programmed value for the parameter of the instruction is too high.
SOLUTION Program a smaller value for the parameter of the instruction.
8242 'Bracket missing'
DETECTION During editing and execution in MDI.
CAUSE The parameters of the programmed instruction must be between brackets. The
variable requires programming an index between brackets.
SOLUTION Check the syntax of the instruction or variable in the programming manual.
8243 '"I" programmed twice'
DETECTION During editing.
CAUSE The I parameter has been programmed more than once in the same block.
SOLUTION Program the I parameter only once in the block.
8244 '"J" programmed twice'
DETECTION During editing.
CAUSE The J parameter has been programmed more than once in the same block.
SOLUTION Program the J parameter only once in the block.
8245 '"K" programmed twice'
DETECTION During editing.
CAUSE The K parameter has been programmed more than once in the same block.
SOLUTION Program the K parameter only once in the block.
8247 'Only R1 can be part of an expression'
DETECTION During editing.
CAUSE The radius has been programmed wrong.
SOLUTION The radius can only be programmed with "R" or "R1".
8250 'Axis variable without writing permission'
DETECTION During editing.
CAUSE The variable has no writing permission.
SOLUTION The variable is read-only.