Error solving manual.
CNC 8060
CNC 8065
·117·
(R
EF
: 1709)
2406
#LEAP with #GAPCTRL ON: The leap must start and end at the same coordinate.
DETECTION
During block preparation.
CAUSE
There is an axis controlled by the instruction #GAPCTRL ON. In this circumstance,
the #LEAP instruction has been programmed to execute a leap where the start and
end coordinates (POS parameter for the #LEAP instruction) do not match.
SOLUTION
The possible solutions are:
• Do not program POS for the #LEAP command
• Remove the gap control (#GAPCTRL OFF).
2407
#LEAP with #GAPCTRL ON: POSLIMIT less than initial leap coordinate.
DETECTION
During block preparation.
CAUSE
There is an axis controlled by the instruction #GAPCTRL ON. In this circumstance,
the #LEAP instruction has been programmed with a lower POSLIMIT (maximum leap
value) than the start and end leap coordinates.
SOLUTION
The possible solutions are:
• Program POSLIMIT for the #LEAP command with a coordinate greater than the
initial leap position.
• Remove the gap control (#GAPCTRL OFF).
2408
#LEAP, #GAPCTRL ON #SWTOUT ON: All three commands cannot be active.
DETECTION
During block preparation.
CAUSE
The commands #LEAP, #GAPCTRL ON and #SWTOUT ON cannot be active at the
same time.
SOLUTION
Deactivate one of the other two active commands.
2409
The slave axis "LASER FOLLOW AXIS" cannot be programmed.
DETECTION
During block preparation.
CAUSE
The slave axis name for #FOLLOW ON [MASTER, slave axis] coincides with the
machine parameter LASERFOLLOWAXIS.
SOLUTION
Do not program the slave axis for #FOLLOW [MASTER].
2410
#PWRCTRL ON/OFF [<DUTY/D/OUT/O> <,OVRMINvalue> <,OVRMAXvalue>
<,FMINvalue> <,FMAXvalue>]
DETECTION
During editing and execution.
CAUSE
The syntax of the instruction is wrong.
SOLUTION
Check the syntax of the instruction in the programming manual.
2411
#PWRCTRL OFF<[DUTY/D/OUT/O]>
DETECTION
During editing and execution.
CAUSE
The syntax of the instruction is wrong.
SOLUTION
Check the syntax of the instruction in the programming manual.
2412
Parameter PWRCTRL out of range.
DETECTION
During editing and execution.
CAUSE
A command in the instruction #PERCTRL has an invalid value.
SOLUTION
Check the syntax of the instruction in the programming manual.
2413
DUTY/OUT must be programmed.
DETECTION
During editing and execution.
CAUSE
The command DUTY/OUT is not programmed for the function #PWRCTRL.
SOLUTION
Check the syntax of the instruction in the programming manual. To activate the power
control (#PWRCTRL), one of the commands DUTY or OUT must be programmed.
2414
PWCTRL DUTY not allowed if there is no PWM software option.
DETECTION
During execution.
CAUSE
To activate the PWM duty control, the "PWM" software option is required.
SOLUTION
Activate the power control (command OUT) to acquire the appropriate software
option.
Summary of Contents for 8065
