Error solving manual.
CNC 8060
CNC 8065
·36·
(R
EF
: 1709)
1212
'#CALL AX/#SET AX: repeated axis number.
DETECTION
During execution.
CAUSE
Two axes try to occupy the same position in the channel.
SOLUTION
Check the program.
1213
'#CALL AX/#SET AX: not allowed when G63 is active'
DETECTION
During execution.
CAUSE
#CALL AX cannot be programmed if function G63 is active.
SOLUTION
Deactivate the threading G63 before modifying the configuration of the axes.
1214
'#CALL AX/#SET AX: too many axes required'
DETECTION
During execution.
CAUSE
Too many axes programmed; the number of axes exceeds the number of axes of the
system.
SOLUTION
Check the configuration of the axes of a channel The number of axes of a channel
cannot exceed the number of axes of the system.
1215
'The #CALL AX/#SET AX instruction must be programmed alone in the block'
DETECTION
During execution.
CAUSE
The instruction has not been programmed alone in the block.
SOLUTION
Check the program.
1216
'#CALL AX/#CAX: axis name being used'
DETECTION
During execution.
CAUSE
The name of one of the axes is being used by a C axis.
SOLUTION
Check the program.
1217
'#CALL AX: index being used'
DETECTION
During execution.
CAUSE
One of the positions is occupied by another axis.
SOLUTION
Check the configuration of the axes defined for the channel, two axes cannot be in
the same position. An axis can use any free position between 1 and a number equal
to the maximum number of axes plus the maximum number of spindles allowed by
the system.
1218
'The #FREE AX instruction must be programmed alone in the block'
DETECTION
During execution.
CAUSE
The instruction has not been programmed alone in the block.
SOLUTION
Check the program.
1219
'"," or "]" expected'
DETECTION
During execution.
CAUSE
Syntax error in the instruction.
SOLUTION
Check the program.
1220
'#FREE AX: an active axis cannot be eliminated in manual mode'
DETECTION
During execution.
CAUSE
An axis in additive manual mode G201 cannot be eliminated from the channel.
SOLUTION
Use function G202 to cancel the additive manual mode of the axis in order remove
the axis from the channel.
1221
'The #SET AX instruction must be programmed alone in the block'
DETECTION
During execution.
CAUSE
The instruction has not been programmed alone in the block.
SOLUTION
Check the program.
1222
'#COMMENT END not expected'
DETECTION
During execution.
CAUSE
There is an end-of-comment block (#COMMENT END), but the open-comment block
(#COMMENT BEGIN) is missing.
SOLUTION
Check the program.
Summary of Contents for 8065
