Fagor 8065, Error Solving Manual

Page: 133 / 220

Error solving manual.
CNC 8060
CNC 8065
·133·
(R
EF
: 1709)
3605 'Spindle turning direction contrary to the setting of the machine parameter'
DETECTION During execution.
CAUSE The programmed rotation requires a spindle movement in the opposite direction to
what has been set by machine parameter UNIDIR.
SOLUTION Check the program and spindle machine parameter UNIDIR.
3606 'The spindle positioning requires an absolute coordinate'
DETECTION During execution.
CAUSE After a spindle turn in open loop, the positioning must always be in absolute
coordinates.
SOLUTION Program the positioning in absolute coordinates.
3607 'The spindle cannot be synchronized while PLCCNTL is active
DETECTION During execution.
CAUSE The CNC has tried to do a synchronization while the PLCCNTL mark was active.
SOLUTION Deactivate the PLCCNTL mark of the PLC.
3608 'PLCCNTL is not possible if the spindle is synchronized'
DETECTION During execution.
CAUSE The PLC has activated the PLCCNTL mark in a spindle that is synchronized, either
as master or as slave.
SOLUTION Deactivate the PLCCNTL mark of the PLC.
3609 '#SERVO ON is not possible if the spindle has not been previously homed'.
DETECTION During execution.
CAUSE A #SERVO ON instruction has been programmed for a spindle that has not been
homed.
SOLUTION Home the spindle, with M19 or G74, before using the #SERVO ON instruction.
3610 'The loop cannot be opened because it is in M19 or in synchronization'
DETECTION During execution.
CAUSE A #SERVO ON instruction has been programmed for a spindle that is in M19.
SOLUTION The #SERVO OFF instruction cancels the #SERVO ON instruction and, if possible,
opens the loop. If the spindle is in M19, the #SERVO OFF instruction cannot open
the loop; to open the loop, program M3, M4, M5 or do a reset.
3611 'The master spindle of the synchronization is not in the right gear (SYNCSET or CAXSET)'
DETECTION During execution.
CAUSE The master or slave spindle is not in the right gear, parameter SYNCSET or parameter
CAXSET if the master spindle is as C axis.
SOLUTION Change the gear of the master and/or slave spindle in its channel or change the
master spindle to the channel of the slave spindle so the gear change is automatic.
3612 'SPDLEREV is not possible if the spindle is synchronized'
DETECTION During execution.
CAUSE The PLC has activated the SPDLEREV mark in a spindle that is synchronized, either
as master or as slave.
SOLUTION Deactivate the SPDLEREV mark of the PLC.
3700 'Axis travel limit overrun'
DETECTION During the movement of the axis.
CAUSE The PLC has tried to overrun the travel limits.
SOLUTION Check the program.
3701 'The reference position is beyond the software limits'
DETECTION During the validation of machine parameters.
CAUSE The value of parameter REFVALUE exceeds the software travel limits of the axis.
SOLUTION Check parameter REFVALUE and the software travel limits.