Fagor 8065, Error Solving Manual

Page: 64 / 220

Error solving manual.
CNC 8060
CNC 8065
·64·
(R
EF
: 1709)
1545 'Spindle gear change is not possible while G63 or #CAX is active'
DETECTION During execution.
CAUSE The CNC cannot change the spindle gear if tapping G63 is active or the spindle is
working as C axis.
SOLUTION Deactivate the threading and the C axis to change the spindle gear.
1546 'G63 not allowed without prior gear at the spindle'
DETECTION During execution.
CAUSE This situation is only possible if after a system power-up or a reset, the PLC does not
indicate any gear with GEAR1 through GEAR4 for the spindle. Then, the spindle has
no active gear and if it is not used before programming G63, the CNC will not generate
a gear automatically, either.
SOLUTION Before starting a G63 tapping, the spindle must have a gear activated. If the spindle
has an automatic gear changer (parameter AUTOGEAR), the CNC generates the
gear when programming a speed; otherwise, the gear (M41-M44) must be
programmed with the speed.
1547 '#CAX not allowed while G63 is active'
DETECTION During execution.
CAUSE A spindle cannot be activated as C axis if it is being used by function G63.
SOLUTION Cancel G63 before deactivating the C axis or use another spindle of the channel for
the C axis.
1548 'The master spindle cannot be changed while G33/G63/G95/G96 are active'
DETECTION During execution.
CAUSE Function G63 and G96 use the master spindle of the channel. The cannel cannot
eliminate this spindle while the functions are active.
SOLUTION Cancel G63 or G96 before releasing the spindle.
1549 'Null or wrong pocket name'
DETECTION During execution.
CAUSE When a 2D or 3D pocket has been defined with the cycle editor, the pocket name has
not been defined or its name is wrong. The pocket name cannot be #DATAP2D or
#DATAP3D generated by the cycle editor.
SOLUTION Assign a different name to the pocket.
1550 'Two C axes cannot be programmed in the same channel'
DETECTION During execution.
CAUSE The CNC has tried to activate a C axis while another one was active.
SOLUTION Deactivate a C axis before activating another one.
1551 'Too many local parameter nesting levels'
DETECTION During execution.
CAUSE The nesting of subroutine calls with #PCALL or with function G1-G190 increases the
nesting level of the local parameters. The error comes up because the maximum
nesting level (7) of local parameters has been exceeded.
SOLUTION Decrease the nesting of subroutines or use the instructions #CALL, L or LL to call
them; they do not increase the nesting level of local parameters.
1552 'The name of the variable must begin with a "V."
DETECTION During execution.
CAUSE The name of a variable has been written from a part program or MDI without the
starting prefix "V."
SOLUTION Add the prefix "V." to the name of the variable.
1553 'Too many user variables'
DETECTION During execution.
CAUSE The CNC has exceeded the maximum number of user variables (prefixes P and S)
admitted.
SOLUTION The maximum number of user variables admitted is 20.