Error solving manual.
CNC 8060
CNC 8065
·131·
(R
EF
: 1709)
3409
'The axis is not valid as independent axis'
DETECTION
During execution.
CAUSE
The CNC tries to execute an operation of independent axis involving an axis that
depends on others or on which others depend (e.g. gantry axes, coupled axes or axes
involved in a transformation) or because it is a DRO axis or it is a module and the lower
limit of the module is negative.
SOLUTION
Cancel the existing coupling (slaving) or the transformations.
3410
'The maximum amount of time allowed for synchronizing has been exceeded'
DETECTION
During execution.
CAUSE
The synchronization does not reach the desired position in the established amount
of time.
SOLUTION
Increase the synchronization time, start the synchronization at more similar speeds
or increase the acceleration of the slave axis.
3411
'An attempt has been made to exceed to the maximum feedrate MAXFEED'
DETECTION
During execution.
CAUSE
An independent axis movement has been programmed with an active
synchronization and the sum of both feedrate components exceeds the maximum
permitted for that axis.
SOLUTION
If the feedrate of the master axis is high, the additional movement must be
programmed with a lower feedrate.
3412
'A "0" denominator cannot be programmed in synchronization'
DETECTION
During execution.
CAUSE
In the synchronization, the denominator of the gear ratio has a zero value.
SOLUTION
The denominator of the ratio cannot be zero.
3413
'It is not possible to synchronize in position with module and ratio other than 1'
DETECTION
During execution.
CAUSE
In position synchronization, the master axis has module and the gear ratio is other
than 1.
SOLUTION
In position synchronization where the master axis has module, the gear ratio must
be 1. Program a gear ratio of 1 or a speed synchronization.
3414
'A cam cannot be programmed for axes whose module value is different'
DETECTION
During execution.
CAUSE
When synchronizing the cam, the master and slave axes have different modules.
SOLUTION
Both axes must have the same module (the same parameters MODUPLIM and
MODLOWLIM).
3415
'Independent home search not allowed in execution'
DETECTION
During execution.
CAUSE
The PLC tries to do a home search while the CNC is executing another one.
SOLUTION
The PLC must wait until the CNC finishes its home search.
3500
'Linear acceleration of section 1 smaller than or equal to zero'
DETECTION
On startup or during execution.
CAUSE
The programmed acceleration is 0.
SOLUTION
Program a positive value for the acceleration.
3501
'Linear acceleration of section 1 greater than the maximum'
DETECTION
During startup or execution.
CAUSE
The programmed acceleration is greater than the maximum.
SOLUTION
Program a smaller value than the maximum for the acceleration.
3502
'Linear acceleration of section 2 smaller than or equal to zero'
DETECTION
On startup or during execution.
CAUSE
The programmed acceleration is 0.
SOLUTION
Program a positive value for the acceleration.
Summary of Contents for 8065
