Fagor 8065, Error Solving Manual

Page: 159 / 220

Error solving manual.
CNC 8060
CNC 8065
·159·
(R
EF
: 1709)
6023 'Error when initializing the handwheel counter'
DETECTION During CNC startup.
CAUSE The counter does not exist. The error window indicates which counter is causing the
error.
SOLUTION Check the machine parameters. If the error persists, contact the Service Department.
6024 'Error when initializing the keyboard handwheel'
DETECTION During CNC startup.
CAUSE The handwheel input does not exist. The error window indicates which handwheel
is causing the error.
SOLUTION Check the machine parameters. If the error persists, contact the Service Department.
6025 'Checksum error at the COMPCI'
DETECTION During execution.
CAUSE Error in the checksum of the data of the digital or analog outputs sent from the PC
to the COMPCI through the common RAM memory.
Error codes for the CANfagor bus.
SOLUTION Contact our technical service department.
6026 'Hardware error at the COMPCI'
DETECTION During system startup.
CAUSE Error during the hardware test of the COMPCI. The following tests are run on start-
up: Flash, common RAM, external RAM, internal RAM and CAN controller.
SOLUTION The diagnoses mode displays detailed information on this type of error. Verify that
the software version of the COMPCI is the right one. Contact our technical service
department.
6027 'Hardware error in remote CAN node'
DETECTION During system startup.
CAUSE Error during the hardware test of the remote nodes. The following tests are run on
start-up: Flash, RAM and CAN controller.
SOLUTION The diagnoses mode displays detailed information on this type of error. Verify that
the software version of the COMPCI is the right one. Contact our technical service
department.
6028 'Error when accessing the RAM of the SERCON'
DETECTION On system startup or during execution.
CAUSE Failure when testing the common RAM of the SERCON executed on CNC start-up
(R/W accesses in Byte/Word modes). The CNC runs this test on power-up and in
every cycle of the Sercos, during phase 4, to check the integrity of the data RAM
memory of the SERCON.
SOLUTION Hardware problem on the Sercos piggy-back or in the connection to the PCI BUS
Contact our technical service department.
6029 'Position increment limit exceeded at the CNC'
DETECTION During execution.
CAUSE Excessive position increment in an analog axis. Hardware failure at the counter node,
Accesses to the COMPCI (connections), etc.
SOLUTION Contact our technical service department.
6030 'Position increment limit exceeded at the CAN counter node'
DETECTION During execution.
CAUSE Excessive position increment in an analog axis. Hardware failure of the counter node.
SOLUTION Contact our technical service department.
6031 'Incompatible software version at COMPCI/Remote nodes'
DETECTION During system startup.
CAUSE Incompatible software version at CNC and COMPCI or remote modules.
SOLUTION Update the software of the COMPCI and remote modules.
Code. Meaning.
1 Analog outputs.
3 Digital outputs.