Fagor 8065, Error Solving Manual

Page: 18 / 220

Error solving manual.
CNC 8060
CNC 8065
·18·
(R
EF
: 1709)
1000-1999
1000 'The function of instruction requires programming the axes'
DETECTION During execution.
CAUSE The axes affected by the programmed instruction or G function have not been
programmed.
SOLUTION Check the program.
1004 'Zero spindle speed'
DETECTION During execution.
CAUSE The speed of the spindle used with function G63 is zero.
SOLUTION Program a spindle speed.
1005 'Motion block with zero feed'
DETECTION During execution.
CAUSE No feedrate is active in the channel.
SOLUTION Program the feedrate F.
1006 'G20: spindle not allowed'
DETECTION During execution.
CAUSE Function G20 does not allow programming the spindle.
SOLUTION Check the program.
1007 'The programmed function requires a nonexistent main axis'
DETECTION During execution.
CAUSE The programmed function needs one or two main axes and they are missing in the
channel.
SOLUTION Check the program. Following functions G11, G12, G13 and G14 require one of the
two axes of the main plane. Functions G2, G3, G8, G9, G30, G36, G37, G38, G39,
G73 require both axes of the main plane. Both axes of the main plane are also needed
to activate collision detection (#CD) and for function G20 when collision detection is
active.
1008 'Coordinates out of range'
DETECTION During execution.
CAUSE The possible causes are:
• The coordinate programmed for the axis is too large.
• Function G101 tries to include an offset too large in the axis.
SOLUTION Check the program.
1009 'G4: the dwell has been programmed twice, directly and using K'
DETECTION During execution.
CAUSE The dwell has been programmed twice in the G4 function and in the same block,
directly with a number and with parameter K.
SOLUTION Program the dwell function G4 only once.
1010 'Program G4 K'
DETECTION During execution.
CAUSE The dwell time has not been programmed in function G4.
SOLUTION Program G4 as G4 <time> or G4K<time>, where <time> is the dwell time in seconds.
In both cases, the dwell must be programmed after G4.
1011 'G4: dwell out of range'
DETECTION During execution.
CAUSE The dwell time programmed in function G4 is too long.
SOLUTION The maximum value allowed for the dwell is 2147483646.