Fagor 8065, Error Solving Manual

Page: 105 / 220

Error solving manual.
CNC 8060
CNC 8065
·105·
(R
EF
: 1709)
2116 'Error when activating the spline'
DETECTION During execution.
CAUSE A spline mode cannot be activating without canceling the previous mode.
SOLUTION Cancel the active spline mode before activating another one.
2118 'SPLINE: Wrong type of spline'
DETECTION During execution.
CAUSE The type of spline programmed is not allowed.
SOLUTION Check the correct format in the programming manual.
2119 'SPLINE: The type cannot be changed while splines are active'
DETECTION During execution.
CAUSE A change of spline type has been programmed without canceling the spline.
SOLUTION Cancel the active spline mode before activating another one.
2121 'Circular paths (arcs) are not allowed while splines are active'
DETECTION During execution.
CAUSE An arc has been programmed while the spline mode is active.
SOLUTION Cancel the spline mode before programming the arc.
2122 'Polynomial blocks are not allowed while splines are active'
DETECTION During execution.
CAUSE A polynomial movement has been programmed while the spline mode is active.
SOLUTION Cancel the spline mode before programming the polynomial.
2123 'Programming not allowed while splines are active'
DETECTION During execution.
CAUSE Being the spline mode active, a coordinate system change has been programmed
or instructions that interrupt block preparation.
SOLUTION Cancel the spline mode before changing the coordinate system or program
instructions that interrupt block preparation.
2124 'SPLINE: It requires at least two main axes'
DETECTION During execution.
CAUSE The spline mode cannot be activated with only one axis in the channel.
SOLUTION Either configure the channel with two axes or program the movements without spline
mode.
2125 'SPLINE: Error when calculating the tangent'
DETECTION During execution.
CAUSE Duplicate points have been programmed.
SOLUTION Program different points.
2126 'Positive software limit overrun in the spline'
DETECTION During execution.
CAUSE The path generated by the CNC to work in spline mode is out of the active travel limits.
SOLUTION Cancel the spline mode in the block or blocks that cause the error.
2127 'Negative software limit overrun in the spline'
DETECTION During execution.
CAUSE The path generated by the CNC to work in spline mode is out of the active travel limits.
SOLUTION Cancel the spline mode in the block or blocks that cause the error.
2128 'Helical path programmed wrong'
DETECTION During execution.
CAUSE Either one of the parameters of the helical path is missing or is wrong. The pitch has
been programmed, but not the depth, both the pitch and the end point are missing
or the depth, the pitch and the end point are not compatible with each other.
SOLUTION Program the end point compatible with the pitch and the depth. If the helical path
makes full turns, program the pitch and the depth.