Fagor 8065, Error Solving Manual

Page: 129 / 220

Error solving manual.
CNC 8060
CNC 8065
·129·
(R
EF
: 1709)
3092 'Work zone limit exceeded'
DETECTION During execution.
CAUSE The CNC has tried to move an axis to a position located outside the no-exit work zone.
The zone may be defined either by program or by PLC (using the work-zone related
variables).
SOLUTION Keep the axes within the limits of the no-exit work zone. If an axis is outside the limits,
jog it in the proper direction using the jog keys.
3093 'Point inside the forbidden zone'
DETECTION During execution.
CAUSE The CNC has tried to move an axis to a position located inside the no-entry work zone.
The zone may be defined either by program or by PLC (using the work-zone related
variables).
SOLUTION Keep the axes out of the limits of the no-entry work zone. If the tool is inside the
forbidden zone, deactivate that zone temporarily, jog the axis in the proper direction
until it is outside the forbidden zone and activate the no-entry zone again.
3095 End point incorrectly programmed in #GAPCTRL or #LEAP.
DETECTION During execution.
CAUSE During the #GAPCTRL or #LEAP instruction, the CNC cannot correct the position
after receiving a sensor signal.
SOLUTION Check that the end point indicated in the #GAPCTRL or #LEAP instruction is correct.
3096 PWRCTRL DUTY activated in another channel.
DETECTION During execution.
CAUSE An attempt has been made to activate #PWRCTRL DUTY on a channel while it active
on another channel.
SOLUTION The #PWRCTRL DUTY can only be active on one channel.
3097 PWRCTRL OUT activated in another channel.
DETECTION During execution.
CAUSE An attempt has been made to activate #PWRCTRL OUT on a channel while it active
on another channel.
SOLUTION The #PWRCTRL OUT can only be active on one channel.
3098 PWRCTRL DUTY requires active PWM in the same channel.
DETECTION During execution.
CAUSE An attempt has been made to activate #PWRCTRL DUTY on a channel without it first
being activated for the same channel.
SOLUTION Activate the PWM before activating #PWRCTRL DUTY.
3100 'Excessive power on the spindle detected during DMC.’
DETECTION During execution.
CAUSE DMC has detected excessive power consumption (drive variable TV51) during a
period of time. This may indicate that the tool has worn down, been damaged or it
has collided with the part.
SOLUTION Check the tool and/or the programming of the deepening pass sequence and the
radial pass sequence.
3101 'Excessive power on the spindle detected during DMC. Press START to continue'
DETECTION During execution.
CAUSE DMC has detected that the instantaneous power (drive variable TV51) has exceeded
the target power in a preset range. This can indicate that the tool has collided with
the part, and so the CNC stops the axes, keeping the spindle turning.
SOLUTION Check the status of the tool and the machining. The CNC allows the execution to be
resumed by pressing [START], to enter in the tool inspection mode or to finish the
execution.
3102 Non-compatible instruction with active independent movement.
DETECTION During execution.
CAUSE An attempt was made to execute the #HSC or #SWT instruction on an axis with
independent motion.
SOLUTION You can not program these instructions on an axis with an independent movement.