Error solving manual.
CNC 8060
CNC 8065
·128·
(R
EF
: 1709)
3080
'The offset of the not-repositioned axis cannot be assumed'
DETECTION
During execution.
CAUSE
The CNC has tried to move an axis that has not been repositioned in a circular path.
SOLUTION
It is not possible to move an axis that has not been repositioned in a circular path.
3081
'Speed too high'
DETECTION
During laser cutting (synchronized switching).
CAUSE
The cutting speed is too high for the size of the grid.
SOLUTION
Lower the speed or shorten the cycle time.
3082
'Too much anticipation to turn the digital output on'
DETECTION
During laser cutting (synchronized switching).
CAUSE
The delay calculated for the laser is negative; i.e. there is no enough margin of cycles
for the anticipation.
SOLUTION
Decrease the cycle time or lower the value of the anticipation parameters.
3083
'Too much delay to turn the digital output on'
DETECTION
During laser cutting (synchronized switching).
CAUSE
Too much delay programmed for the laser.
SOLUTION
Check the value of the anticipation parameters TON / TOF.
3084
'Driver error when turning laser ON/OFF'
DETECTION
During laser cutting (synchronized switching).
CAUSE
The necessary hardware and parameter setting conditions to use the laser cutting
feature are not met.
SOLUTION
Check the following conditions:
• There must be a Sercos type expansion board, with software ID equal to or higher
than 1.2.
• The value of parameter NLOCOUT must be 8.
• The value of parameter PWMOUTPUT must not be higher than 2 (0, 1, 2).
3087
'PWM activated in another channel'
DETECTION
During laser cutting (PWM).
CAUSE
The PWM feature is already activated in a channel other than than desired one.
SOLUTION
Check how the arc has been programmed.
3088
'Error when programming the laser mask'
DETECTION
During laser cutting (synchronized switching).
CAUSE
The necessary hardware and parameter setting conditions to use the laser cutting
feature are not met.
SOLUTION
Check the following conditions:
• There must be a Sercos type expansion board, with software ID equal to or higher
than 1.2.
• The value of parameter NLOCOUT must be 8.
• The value of parameter PWMOUTPUT must not be higher than 2 (0, 1, 2).
3089
'Error when calculating the reverse transformation of the virtual axis of the tool, #VIRTAX'
DETECTION
During execution.
CAUSE
The transformation from part coordinates to machine coordinates cannot be
executed.
SOLUTION
Contact Fagor.
3090
'Error when calculating the direct transformation of the virtual axis of the tool, #VIRTAX'
DETECTION
During execution.
CAUSE
The transformation from machine coordinates to part coordinates cannot be
executed.
SOLUTION
Contact Fagor.
Summary of Contents for 8065
