Error solving manual.
CNC 8060
CNC 8065
·104·
(R
EF
: 1709)
2101
'Negative software limit overrun in G5, G60 or HSC'
DETECTION
During execution.
CAUSE
The path generated by the CNC in G05, G60 or HSC mode is beyond the active travel
limits.
SOLUTION
Check that the programmed path is within the software limits and execute it in G7 or
G50 to avoid overshooting. If necessary, cancel the HSC mode (#HSC OFF).
2102
'Programming instruction #ROUNDPAR with parameter too small'
DETECTION
During execution.
CAUSE
The programmed contour error is too small to be processed.
SOLUTION
Program the instruction with a contour error greater than 20 microns.
2103
'Programming instruction #ROUNDPAR with the wrong type of parameter'
DETECTION
During execution.
CAUSE
The programmed rounding type is not valid.
SOLUTION
Check the format of the instruction in the programming manual.
2106
'Internal error in HSC mode'
DETECTION
During execution.
CAUSE
Error when calculating the tool path to work in HSC mode.
SOLUTION
Cancel the HSC mode in the block or blocks that cause the error.
2108
'HSC: mode change not allowed'
DETECTION
During execution.
CAUSE
The HSC mode cannot be changed without canceling the previous mode.
SOLUTION
Cancel the HSC mode before programming another one.
2109
'HSC: Contour error too small'
DETECTION
During execution.
CAUSE
The programmed contour error is too small to be processed.
SOLUTION
Program the instruction with a contour error greater than 20 microns.
2110
'Positive software limit overrun in HSC mode'
DETECTION
During execution.
CAUSE
The path generated by the CNC to work in HSC mode is out of the active travel limits.
SOLUTION
Cancel the HSC mode in the block or blocks that cause the error.
2111
'Negative software limit overrun in HSC mode'
DETECTION
During execution.
CAUSE
The path generated by the CNC to work in HSC mode is out of the active travel limits.
SOLUTION
Cancel the HSC mode in the block or blocks that cause the error.
2112
'Undetermined initial tangent in spline'
DETECTION
During execution.
CAUSE
Either the starting point of the spline is not the same as the previous point, thus the
tangent is undetermined or only one axis of the tangent has been programmed.
SOLUTION
Program a point before the spline entry point or both axes of the tangent.
2113
'Undetermined final tangent in spline'
DETECTION
During execution.
CAUSE
Either the final point of the spline is not the same as the later point, thus the tangent
is undetermined or only one axis of the tangent has been programmed.
SOLUTION
Program an exit point after the final point of the spline or both axes of the tangent.
2114
'Spline activating command not allowed'
DETECTION
During execution.
CAUSE
The spline mode cannot be activated without finishing a previous spline.
SOLUTION
Cancel the active spline mode before defining a new one.
2115
'Programming instruction #ASPLINE with wrong parameter'
DETECTION
During execution.
CAUSE
The type of tangency is wrong.
SOLUTION
Check the correct format in the programming manual.
Summary of Contents for 8065
