Fagor 8065, Error Solving Manual

Page: 178 / 220

Error solving manual.
CNC 8060
CNC 8065
·178·
(R
EF
: 1709)
8283 'Wrong parameter in canned cycle'
DETECTION During editing.
CAUSE The parameter programmed for this canned cycle is wrong.
SOLUTION Check the programming manual for the parameters required and allowed by each
canned cycle.
8284 'PLC variable without writing permission'
DETECTION During editing.
CAUSE The variable has no writing permission.
SOLUTION The variable is read-only.
8285 'G20: negative sign only allowed on the longitudinal axis'
DETECTION During editing.
CAUSE An axis that is not longitudinal has been programmed with a negative sign in function
G20.
SOLUTION In G20, only the longitudinal axis can have a negative sign.
8287 'The limits of the whole portion have been exceeded'
DETECTION During editing and execution.
CAUSE The syntax of the instruction is wrong.
SOLUTION Check the syntax of the instruction in the programming manual.
8288 'The limits of the fractional portion have been exceeded'
DETECTION During editing and execution.
CAUSE The syntax of the instruction is wrong.
SOLUTION Check the syntax of the instruction in the programming manual.
8290 'Variable of the tool manager without writing permission'
DETECTION During editing.
CAUSE The variable has no writing permission.
SOLUTION The variable is read-only.
8291 'Variable of the machine parameters without writing permission'
DETECTION During editing.
CAUSE The variable has no writing permission.
SOLUTION The variable is read-only.
8295 'Empty parameter list'
DETECTION During editing and execution.
CAUSE The syntax of the instruction is wrong.
SOLUTION Check the syntax of the instruction in the programming manual.
8296 'Repeated or incompatible parameter'
DETECTION During editing and execution.
CAUSE The syntax of the instruction is wrong.
SOLUTION Check the syntax of the instruction in the programming manual.
8297 'Parameter repeated'
DETECTION During editing.
CAUSE The possible causes are:
• The parameter CONTERROR has been programmed more than once in the
#HSC instruction.
• In the subroutine calling instruction #PCALL, #MCALL or G function with
associated subroutine, some parameter has been written more than once.
• Some parameter has been programmed more than once in the #PROBE or
#POLY instruction.
SOLUTION Program each parameter only once in the block.
8299 'Brackets missing around the list of parameters'
DETECTION During editing and execution in MDI.
CAUSE The programmed instruction requires that its list of parameters be between brackets.
SOLUTION Check the syntax of the instruction in the programming manual.