Fagor 8065, Error Solving Manual

Page: 123 / 220

Error solving manual.
CNC 8060
CNC 8065
·123·
(R
EF
: 1709)
3026 'Negative software travel limit overrun'
DETECTION During execution.
CAUSE The CNC has tried to move an axis to a point located beyond the software limits.
SOLUTION The axes must always be within the software limits. Check that the software limits are
correct, that they have not been modified via part-program or by PLC.
3027 'Error when calculating the reverse RTCP transformation'
DETECTION During execution.
CAUSE The CNC cannot execute the transformation from part-coordinates to machine
coordinates.
SOLUTION Contact Fagor.
3029 'Error when calculating the direct RTCP transformation'
DETECTION During execution.
CAUSE The CNC cannot execute the transformation from machine-coordinates to part
coordinates.
SOLUTION Contact Fagor.
3030 'Simulated axes cannot be mixed with non-simulated axes'
DETECTION During execution.
CAUSE There are simulated axes and non-simulated ones in the process of measuring with
a probe
SOLUTION All the axes involved in a process of measuring with a probe must be of the same type.
3031'(RTCP/TLC) compensation not allowed in the current status.
DETECTION During execution.
CAUSE The CNC has tried to activate one of the RTCP or TLC compensations while the other
one was active.
SOLUTION Both compensations cannot be active at the same time; cancel one of them
(#RTCP OFF / TLC OFF) before activating the other one.
3032 'Home search not possible in DRO mode'
DETECTION During execution.
CAUSE The CNC has tried to do a home search on a DRO axis.
SOLUTION The CNC does not allow doing a home search on a DRO axis.
3033 'It is not possible to switch to manual mode if the axis is at the rotation center'
DETECTION During execution.
CAUSE The CNC tries to activate the jog mode while the face C axis transformation is active
and the axes are in the center of rotation.
SOLUTION Activate the manual mode with the axes in a different position from that of the rotation
center.
3034 'Wrong set number
DETECTION During execution.
CAUSE The CNC tries to access a parameter set that does not exist.
SOLUTION The set number must be between 1 and parameter NPARSET.
3035 'The difference between the following errors of slaved (coupled) axes is too large'
DETECTION During execution.
CAUSE In a gantry axis, the difference between the following error of the master axis and that
of the slave axis is greater than the value defined in parameter MAXCOUPE; in an
axis coupling, the difference is greater than the defined value.
SOLUTION Adjust the dynamic behavior of both axes in a similar way or increase the amount of
error allowed.
3036 'Wrong gear change process'
DETECTION During execution.
CAUSE The spindle gear in the CNC's history and the one indicated by the PLC as being
active are not the same.
SOLUTION Check the PLC program.