Fagor 8065, Error Solving Manual

Page: 124 / 220

Error solving manual.
CNC 8060
CNC 8065
·124·
(R
EF
: 1709)
3037 'Axis locked'
DETECTION During execution.
CAUSE The CNC tries to move an axis, but the PLC has set the signal SERVO(axis)ON.
SOLUTION Check the treatment of the SERVO(axis)ON signal in the PLC program or increase
the value of the DWELL parameter of the axis. The CNC can issue this error when
it works on block blending (G50, G5 or HSC) and it is necessary to force the axis stop
(with an M or G7) before moving the "dead" axis.
3038 'Too many parameters pending to be reported'
DETECTION During execution.
CAUSE The system is overloaded.
SOLUTION Close the applications that are not related to the CNC. If the error persists, contact
Fagor.
3039 'The stop block has not been found in the block search'
DETECTION During execution.
CAUSE The block search does not go through the stop block.
SOLUTION Change the stop block.
3040 'Hirth axis positioned wrong'
DETECTION During execution.
CAUSE The Hirth axis is not positioned in a multiple number of its step.
SOLUTION Position the Hirth axis properly in a valid position or cancel it as Hirth axis.
3041 'No spindle has been defined for G33/G95'
DETECTION During execution.
CAUSE Functions G33 and G95 need a spindle to work. This spindle is by default the master
spindle of the channel, but if PLC register SYNC indicates another spindle, the
channel will use the latter. The CNC will show an error if none of the spindles has
been defined.
SOLUTION Define a master spindle in the channel or assign a spindle to PLC register SYNC.
3042 'The spindle indicated in the SYNC register does not exist'
DETECTION During execution.
CAUSE A G33 or G95 function is active and the value of PLC register SYNC is not valid.
SOLUTION The value of PLC register SYNC must be a value between 1 and the number of
spindles of the system. It can also have a zero value.
3043 'Spindle in M5 when activating electronic threading'
DETECTION During execution.
CAUSE The spindle used in an electronic threading (G33) is stopped or an M5 has been
programmed in the same block as the G33.
SOLUTION The spindle used for electronic threading must be running. Set the spindle running
in a previous block or in the same block as G33.
3044 'An axis active as an independent axis cannot be homed (referenced)'
DETECTION During execution.
CAUSE The CNC tries to do a home search on an independent axis.
SOLUTION If the axis has an independent movement left to make, wait until it completes it or abort
the movement from the PLC (mark IABORT) or with a reset in the channel. If the axis
is synchronized, cancel the synchronization or do a reset in the channel.
3045 'M6 not admitted'
DETECTION During execution.
CAUSE After interrupting a program and changing to MHFS mode, the user has edited an
M6 that is not allowed.
SOLUTION The tool change does not permit resuming the execution of the interrupted program.
Press reset and execute M6 from the MDI mode.
3046 'The associated spindle does not belong to the channel'
DETECTION During execution.
CAUSE After interrupting a program and changing to MHFS mode, the user has edited an
M or an S referred to a spindle that does not exist in the channel or in the system.
SOLUTION Associate the function to the correct spindle. Access the spindle from the channel
where it is.