Error solving manual.
CNC 8060
CNC 8065
·122·
(R
EF
: 1709)
3011
'Too many axis programmed as probe'
DETECTION
During execution.
CAUSE
The number of axes programmed in the probing movement exceeds the maximum
number of axes of the channel.
SOLUTION
Correct the programming of the probing block.
3013
'Braking distance greater than parameter PROBERANGE'
DETECTION
During execution.
CAUSE
The distance required to brake with the active feedrate is greater than the maximum
distance admitted (parameter PROBERANGE), maybe due to the following error.
SOLUTION
Reduce the probing feedrate or reduce the amount of following error.
3015
'During block search, the home search is left out'
DETECTION
During execution.
CAUSE
During a block search, the CNC has found a home search and it has ignored it.
SOLUTION
Search home outside the program.
3016
'During the block search, the jog mode is left out'
DETECTION
During execution.
CAUSE
The user has tried to activate the jog mode during a block search and the CNC has
ignored it.
SOLUTION
The CNC does not allow activating the jog mode during a block search.
3017
'Block search already activated'
DETECTION
During block search.
CAUSE
The CNC has tried to activate a block search while another one was active.
SOLUTION
Contact your supplier.
3018
'The constant surface speed has not been reached yet'
DETECTION
During execution.
CAUSE
The spindle has not had the time to reach the programmed speed.
SOLUTION
Reduce the feedrate, decrease the spindle speed or program the speed before to give
the spindle enough time reach its speed.
3019
'The feedrate programmed in G95 is too low'
DETECTION
During execution.
CAUSE
The resulting feedrate is very small for the programmed speed.
SOLUTION
Increase the feedrate or increase the spindle rpm.
3020
'S has not been programmed in G96'
DETECTION
During execution.
CAUSE
The spindle speed is zero.
SOLUTION
Program a speed.
3021
'The maximum constant surface speed is zero'
DETECTION
During execution.
CAUSE
The maximum spindle speed is zero.
SOLUTION
Program a speed.
3022
'Error when initializing the coordinates of the axes'
DETECTION
During execution.
CAUSE
The coordinates of an axis do not match.
SOLUTION
Contact Fagor.
3023
'Axes missing in the new coordinate system'
DETECTION
During execution.
CAUSE
One of the first three axes of the new coordinate system is missing.
SOLUTION
Define the first three axes of the channel using the instruction #SET AX.
3025
'Positive software travel limit overrun'
DETECTION
During execution.
CAUSE
The CNC has tried to move an axis to a point located beyond the software limits.
SOLUTION
The axes must always be within the software limits. Check that the software limits are
correct, that they have not been modified via part-program or by PLC.
Summary of Contents for 8065
