Fagor 8065, Error Solving Manual

Page: 143 / 220

Error solving manual.
CNC 8060
CNC 8065
·143·
(R
EF
: 1709)
4000(5) 'Error when initializing the Sercos ring'
VALUE 5.
TRANSITION 3.
VALUE 35.
CAUSE Error when resetting errors after initializing the Sercos ring.
SOLUTION Contact our technical service department.
4001 'Parameter LOOPTIME different at the CNC and at the drive'
VALUE Parameter value at the CNC.
VALUE Parameter value at the drive.
AXIS Logic number of the axis
CAUSE Value of the parameter LOOPTIME different at the CNC and at the drive.
SOLUTION Set it to the same at the CNC and at the drive.
4002 'Parameter OPMODE different at the CNC and at the drive'
VALUE Parameter value at the CNC.
VALUE Parameter value at the drive.
AXIS Logic number of the axis
CAUSE Value of the parameter OPMODE different at the CNC and at the drive.
SOLUTION Set it to the same at the CNC and at the drive.
4003 'Parameter AXISMODE different at the CNC and at the drive'
VALUE Parameter value at the CNC.
VALUE Parameter value at the drive.
AXIS Logic number of the axis
CAUSE Value of the parameter AXISTYPE different at the CNC and at the drive.
SOLUTION Set it to the same at the CNC and at the drive.
4004 'Parameter G00FEED higher at the CNC than at the drive'
VALUE Parameter value at the CNC.
VALUE Parameter value at the drive.
AXIS Logic number of the axis
CAUSE Value of the parameter G00FEED different at the CNC and at the drive.
SOLUTION Set it to the same at the CNC and at the drive.
4005 'Following error monitoring not active at the drive'
VALUE 0.
VALUE PP159 parameter value at the drive.
AXIS Logic number of the axis
CAUSE 'Following error monitoring not active at the drive'
SOLUTION Activate parameter PP159 at the drive.
4006 'Drive parameter SP100 must be 0'
VALUE 0.
VALUE SP100 parameter value at the drive.
AXIS Logic number of the axis
CAUSE The drive does not have an additional command enabled.
SOLUTION Set drive parameter SP100 to 0.
4007 'The Sercos spindle needs a gain other than 0'
VALUE 0.
VALUE KV value at the drive.
AXIS Logic number of the axis
CAUSE The spindle KV is 0.
SOLUTION Set the drive's KV to a value other than 0.
4008 'Sercos ring Error+ because the drive has been reset'
AXIS Logic number of the axis
CAUSE Warning that the drive has been reset.
SOLUTION Ignore voluntary resets of the drive with the reset button, WinDDS (recording the
version, soft reset) or hardware problems at the drive. If the error persists, contact
the Service Department.