You cannot set this configuration for a peer that is associated with a peer group. Similarly, you cannot associate a
peer to a peer group if that peer is already configured with these settings.
CAUTION:
Inbound update storage is a memory-intensive operation. The entire BGP update database
from the neighbor is stored in memory regardless of the inbound policy results applied on the neighbor.
NOTE:
This command is supported in BGP Router Configuration mode for IPv4 Unicast address
only.
Related Commands
•
— display routes received by a neighbor.
neighbor timers
Set keepalive and hold time timers for a BGP neighbor or a peer group.
Syntax
neighbor {
ip-address
|
peer-group-name
} timers
keepalive holdtime
To return to the default values, use the
no neighbor {
ip-address
|
peer-group-name
} timers
command.
Parameters
ip-address
Enter the IP address of the peer router in dotted decimal format.
peer-group-name
Enter the name of the peer group to set the timers for all routers within the peer group.
keepalive
Enter a number for the time interval, in seconds, between keepalive messages sent to the
neighbor routers. The range is from 1 to 65535. The default is
60 seconds
.
holdtime
Enter a number for the time interval, in seconds, between the last keepalive message and
declaring the router dead. The range is from 3 to 65535. The default is
180 seconds
.
Defaults
•
keepalive =
60 seconds
•
holdtime =
180 seconds
Command Modes
ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
Border Gateway Protocol
401
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...
