Usage Information
When you enable
debug spanning-tree bpdu
for multiple interfaces, the software only sends information on
BPDUs for the last interface specified.
Related Commands
•
— enters SPANNING TREE mode on the switch.
description
Enter a description of the spanning tree.
Syntax
description {
description
}
To remove the description from the spanning tree, use the
no description {
description
}
command.
Parameters
description
Enter a description to identify the spanning tree (80 characters maximum).
Defaults
none
Command Modes
SPANNING TREE (The prompt is “config-stp”.)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.7.1.0
Introduced
Related Commands
•
— enter SPANNING TREE mode on the switch.
disable
Disable the spanning tree protocol globally on the switch.
Syntax
disable
To enable Spanning Tree Protocol, use the
no disable
command.
Spanning Tree Protocol (STP)
1567
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...