Dell S6100, Руководство по настройке

Страница: 410 / 1743

Usage Information
You can use the
redistribute
command to advertise the IGP cost as the MED on redistributed routes. When
you set the route-map with metric-type internal and apply outbound to an EBGP peer/peer-group, the advertised
routes corresponding to those peer/peer-groups have the IGP cost set as
MED .
When you enter the
redistribute isis process-id
command without any other parameters, Dell
Networking OS redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. RFC does
not support this feature.
router bgp
To configure and enable BGP, enter ROUTER BGP mode.
Syntax router bgp as-number
To disable BGP, use the
no router bgp as-number
command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535 (2 byte), from 1 to 4294967295 (4
byte), or from 0.1 to 65535.65535 (dotted format).
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information At least one interface must be in Layer 3 mode for the
router bgp
command to be accepted. If all interfaces are
configured under VRF, at least one interface should be in the default VRF for the
router
bgp
command to be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
410 Border Gateway Protocol