Dell S6100, Руководство по настройке

Страница: 120 / 1743

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
If you use only the
reload
command, the system boots into the Dell Networking OS.
If there is a change in the running configuration, the system prompts you to save the new configuration when you
reload the system using the
reload
command. You can also save your running configuration manually using the
copy running-config
command.
You can use the
conditional
parameter if any configuration changes made to the NVRAM, such as, stack-
group and fanout configurations, must be saved.
Example
The following example shows how to reload the system:
Dell# reload
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into Dell diagnostics mode:
Dell#reload dell-diag
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE mode:
Dell#reload onie
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE prompt and enter the install mode directly:
Dell#reload onie install
Proceed with reload [confirm yes/no]: yes
send
Send messages to one or all terminal line users.
Syntax send [*] | [line ] | [console] | [vty]
Parameters
* Enter the asterisk character
*
to send a message to all tty lines.
line Send a message to a specific line. The range is from 0 to 11.
console Enter the keyword
console
to send a message to the primary terminal line.
120 Control and Monitoring