Dell S6100, Руководство по настройке

Страница: 292 / 1743

The default frequency at which ACL logs are generated is five minutes. By default, flow-based monitoring is not
enabled.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4(0.0) Added the support for flow-based monitoring on the S4810, S4820T, S6000, and Z9000
platforms.
9.3(0.0) Added the support for logging of ACLs on the S4810, S4820T, and Z9000 platforms.
Usage Information
When the configured maximum threshold is exceeded, generation of logs is stopped. When the interval at which
ACL logs are configured to be recorded expires, the subsequent, fresh interval timer is started and the packet
count for that new interval commences from zero. If ACL logging was stopped previously because the configured
threshold is exceeded, it is re-enabled for this new interval.
If ACL logging is stopped because the configured threshold is exceeded, it is re-enabled after the logging interval
period elapses. ACL logging is supported for standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You
can configure ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable logging for ACLs
that are associated with egress interfaces.
You can activate flow-based monitoring for a monitoring session by entering the flow-based
enable
command in
the Monitor Session mode. When you enable this capability, traffic with particular flows that are traversing through
the ingress and egress interfaces are examined and, appropriate ACLs can be applied in both the ingress and
egress direction. Flow-based monitoring conserves bandwidth by monitoring only specified traffic instead all traffic
on the interface. This feature is particularly useful when looking for malicious traffic. It is available for Layer 2 and
Layer 3 ingress and egress traffic. You may specify traffic using standard or extended access-lists. This mechanism
copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port. The source port
is the monitored port (MD) and the destination port is the monitoring port (MG).
Related Commands
• deny — assign a filter to deny IP traffic.
• deny udp — assign a filter to deny UDP traffic.
deny ether-type (for Extended MAC ACLs)
Configure an egress filter that drops specified types of Ethernet packets on egress ACL supported line cards. (For more information, refer
to your line card documentation).
Syntax deny ether-type protocol-type-number { destination-mac-address mac-address-mask
| any} vlan vlan-id { source-mac-address mac-address-mask | any} [count [byte]]
[order] [log [interval minutes ] [threshold-in-msgs [count]] [monitor]
292 Access Control Lists (ACL)