Dell S6100, Руководство по настройке

Страница: 766 / 1743

Defaults Enabled; the hops field in the DHCP message header is incremented by default.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.3.1.0 Introduced for the E-Series.
Usage Information This command disables the incrementing of the hops field when boot requests are relayed to a DHCP server
through Dell Networking OS. If the incoming boot request already has a non-zero hops field, the message is relayed
with the same value for hops. However, the message is discarded if the hops field exceeds 16, to comply with the
relay agent behavior specified in RFC 1542.
Related Commands
• ip helper-address — specify the destination broadcast or host address for DHCP server requests.
• show running-config — display the current configuration and changes from the default values.
ip host
Assign a name and an IP address to the host-to-IP address mapping table.
Syntax ip host name ip-address
To remove an IP host, use the
no ip host name [ ip-address ]
command.
Parameters
name Enter a text string to associate with one IP address.
766 IPv4 Routing