Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for VRF. Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
Usage Information
Use this command to confirm that the neighbor adjacencies are operating correctly. If you suspect that they are
not, you can verify the specified area addresses of the routers by using the
show isis neighbors
command.
The following describes the
show isis neighbors
command shown in the following example.
Field
Description
System Id
The value that identifies a system in an area.
Interface
The interface, slot, and port in which the router was discovered.
State
The value providing status about the adjacency state. The range is Up and Init.
Type
This value displays the adjacency type (Layer 2, Layer 2 or both).
Priority
IS-IS priority the neighbor advertises. The neighbor with highest priority becomes the
designated router for the interface.
Uptime
Displays the interfaces uptime.
Circuit Id
The neighbor’s interpretation of the designated router for the interface.
Example
The bold sections below identify that Multi-Topology IS-IS is enabled. This command displays only one IP address
per line.
Dell# show isis neighbors
System Id Interface State Type Priority Uptime Circuit Id
TEST Te 1/1/7/1 Up L1L2
(M)
127 09:28:01 TEST.02
!
Dell#show isis neighbors detail
System Id Interface State Type Priority Uptime Circuit Id
TEST Te 1/1/7/1 Up L1L2
(M)
127 09:28:04 TEST.02 Area Address(es):
49.0000.0001
IP Address(es): 25.1.1.3*
MAC Address: 0000.0000.0000
Hold Time: 28
Link Local Address: fe80::201:e8ff:fe00:492c
Topology: IPv4 IPv6 , Common (IPv4 IPv6 )
Adjacency being used for MTs: IPv4 IPv6
Dell#
Intermediate System to Intermediate System (IS-IS)
897
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...